Hi, I would like to change timing chain for my engine: range rover 2008 3.6L V8.

posted now 3 times.
no engine stated (of the 3)
no symptoms stated. or job.
front or rear , oBD2 sensor not stated.
on your other post, i answred for all 3 engine
front 02 sensor B1S1.
all 3 engines, the ECU schematics on the 02 pins.

go back and read. your other posts.

you posted 3 times, and all 3 times same question
but if you read your other posts, bingo.
you never said the symptoms
nor said if it is the front or rear 02 sensor.
so i toss coin and land FRONT. B1S1.
i did answer for all 3 engines,
documented the
oxygen sensor B1S1 on all 3 ECU's

so , look.? at them.?

If this is on a V8 with the BMW M62 engine, it is a major operation best done by BMW mechanics. Special tools are required to locate the camshaft and the VANOS system. It will not be cheap!

land rover discovery v8i 3.9 1995

cant understand why you have no door lock it must have one unless you do not have the correct ket as its been changed at some time ,if so then i would climb under car with some twin flex cable from a 12v battery and then connect the`positive feed to the starter motor supplu and the other cable to the engine or gearboc then it will open with the remote

bearings don't rattle --they knock and the knock gets louder with rpm
it has a chain drive for the cam shaft and rattles are associated with a worn chain as there is no slack adjuster
The v8 engine (originally a 4 litre ) was only stroke by 10 mm to give it extra power
there was never any problem with the block from cracking as that engine was used in the Leyland truck and p38 car as well as range rover cars and off road vehicles
it's big draw card was the power to weight ratio being an aluminium cast block it was suited to fast car applications

Based upon the time that has passed, if you already have not done so, go to: http://www.roverparts.com/Instructions/Firing_Order_and_Ignition_Cable_routing.cfm
This has the wiring diagrams/schematics for your vehicle, including the Distributor and Engine.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

The 3.0 engines has 2 timing chains.it has left side timing chain and a right side timing chain.if you planning to change timing chains.besure to replace timing chain tensioners.

Yes the Land Rover 4.0L Motor is a V6 (6 Cylinder)