Where is the fuel filter located in the 2007 Nissan Quest?

The fuel filter is part of the fuel pump, so if you are wanting to change the fuel filter, the fuel pump must be changed as well. The fuel pump is located in the fuel tank and the fuel tank would need to be dropped to remove the fuel pump.

Here's a link to where your fuel filter is... How do you change the Fuel Filter on 2000 Nissan Quest and

Follow your fuel lines from the the engine back to the tank.They usually run right along the frame.Check for your filter along the lines you will see a filter in there somewhere.

hello good day, reverse your air filter, make the bottom to top,, if is not work change the high tension wires

It's might be immobilized try the spare key or get it code read that should point u in the right direction

Well first if you smell gasoline don't start the vehicle, check the entire fuel system locate the filter and check for leaking, also this vehicle uses a cabin filter to filter incoming air to the passenger compartment, locate this filter and replace it. there located sometimes behind the glove box door, or under the front cowling under the hood, in that space just under the wipers, If you can't find the solution and the smell persists, you need professional help ( with the car)

This particular model does not come equipped with a Cabin Air Filter.

Starting at the fuel tank.. follow the fuel lines towards the front of the car. Make sure when you replace the fuel filter that you put the arrow on the fiter the right direction, otherwise there will be no flow and the engine will not start,

Good Luck!

I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.

It is under hood,driver side,rear engine area,passenger side of master cylinder, mounted on firewall.