The day time running lamps are the high beam lamps , just going through the DRL resistor . Your low beam bulb could be bad (open) . Check voltage with DVOM - digital volt ohm meter , there should be three wires at the headlamp socket , check the orange wire for battery voltage with low beams on .
SOURCE: Driver side headlight bulbs burned out on 2003 VW Golf
There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in. (I say clamps, but they're more like glorified paper clips on either side of the fixture.) Press in on each side, pushing the clamps towards each other and pull the fixture out.
SOURCE: Removal of headlight housing to replace lowbeam bulb.
found this online- haven't tried yet though--
How do you change a headlight bulb on a 2003 Toyota Celica GT?
Under the plastic covering the headlight there is a lot of fog and condensation and I want to clean it off, so how do I take off the plastic that covers the headlight?
Seem to be seal is wear off
already on the front cover
The way to open that
1. There is four screws at the back of
the headlights and unscrew them
2. Pull the headlight and dry it
by wiping or heat of the sun or
anything that can release the fog
3. Buy silicon and seal the headlight
gap with silicon and let it dry for a hour
This will help kept away fog
and condensation for sure
SOURCE: hyundai santa fe 03 running problems
If your Santa Fe has a V6 engine 2.7L , it sounds like you have an ignition break down happening. You will need to renew all the ignition wires and check the two coils also for arcing .
SOURCE: how to change blower motor in a 2003 hyundai santa fe
try these two websites www.alldatadiy.com and www.autozone.com and you should be able to get pictures and diagrams showing you how to repair your truck
zoom
383 views
Usually answered in minutes!
×