SOURCE: Where is the location of the knock sensor for a 2005 HD 2500 6.0
HAS TWO KNOCK SENSORS they are both under intake in valley of engine. remove intake and will see two black grommets they are under those best to replace both at same time
SOURCE: MAF Sensor 2004 Dodge Stratus
If your car has a MAF (Mass Air Flow) sensor, it would be located in the air delivery tube that runs from the air filter box to the throttle plate assembly on the intake manifold. It will have a wiring connector going to it, also. The MAF does exactly what it is called: It "senses" the volume, or "mass" of the air-flow; thusly it needs to be in the intake air tube. If you do NOT have such a device in the air-tube, you have a MAP sensor, (Manifold Absolute Pressure); this is another way of measuring the same air volume, albeit older technology. You will commonly find this device on the firewall, with a vacuum line running to the intake manifold.
I hope that this sheds some light on your question.
Thanks for choosing FixYa for advice!
SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE
Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?
SOURCE: 2005 DODGE STRATUS HOW TO REPLACE THE BATTERY
REMOVAL
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
SOURCE: a bad camshaft position sensor for a 2.4L 2005 dodge stratus
THE CAMSHAFT POSITION SENSOR IS LOCATED ON THE LEFT SIDE OF THE HEAD. 2 BOLTS AND AN OVAL FLANGE. IT HAS A RED LOCK ON THE PLUG WHICH YOU JUST MOVE TO THE RIGHT TO RELEASE THE MAIN PLUG. BUT I dont know if thats your problem. the timing belt seems to fail on these cars prematurely. Dodge recomends 90,000 miles but many cars bend engine valves before this due to the timing belt. (around 83000-88000) miles. I would reccomend having someone look into this problem first. Also trying this yourself can be costly, simply because the timing belt MUST be installed properly and exactly. If this is not done the engine could be at risk causing expensive repairs. Ihave a friend who had the timing belt replaced by an individual and the i recieved it on a tow truck. Which it now cost them 1600.00 to repair. I have been a mechanic for 15 years. But i got smart and went back to college and npw i am a refrigeration technition. Just trying to help you out. any ? [email protected] i would be glad to help.
506 views
Usually answered in minutes!
×