I would hazard a guess that you have a multiple cylinder misfire and your vehicle computer has gone into "limp mode" prevent further damage feom.happening to the vehicle.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, your trans sounds like a clutch slipping in drive or worn,
If it hasn't done to much damage to the clutch plates, sometimes the damaged parts can be changed, you'll find that most mechanics will want to rebuild it so there's no come backs,
i'd get your local trans guy to have a look,
might just need the bands adjusted,??
good luck......
run the fault codes to find the sensor that is putting the light on and replace/repair the faulty unit. It is simply very false economy to run tanks empty as the fuel pumps need fuel to lubricate the gears and if that is intermittent of not there that plastic gears fail and pumps are not cheap.
rear wheels need balancing most cars when you get them balanced are only set up to do speed limit 70 try this first before you start spending money if its front wheel drive there is not a lot else aprt from wheel bearings but you should hear a howling noise if no noise wheels balancing
Have you checked the tranny fluid could be low on fluid. This would cause it not to shift or jump into gear. Also make sure the shifter is moving on the tranny a linkage could have come loose.
THE ORIGINAL VIBRATION MAY HAVE BEEN TIRES.IF THE LUG NUTS WERE NOT TORQUED BY HAND BUT OVERTIGHTED W/AN AIR RATCHET THE ROTORS MAY HAVE BEEN WARPED.TAKE IT BACK TO WERE THE TIRES WERE INSTALLED AND ASK THEM TO CHECK IT OUT.
×