I looked at info for the 3.7L engine, looks fairly straight forward. Take negative battery cable loose and isolate. Remove generator belt. Remove electrical connector from generator. Remove bolts from generator. Remove generator.
If your going to work on your own vehicle, you need a basic set of tools, wrenches and sockets, standard and metric sizes. I don't know the actual socket or wrench size.
SOURCE: 2007 Dodge Nitro Tail Light Replacement
look at the car manual under maintenance and then rear light bulb replacement. First take out the two hole covers using a flat head to loosen then wiggle and turn by hand to get out. Pull the light unit straight back, and unplug the electrical. Don't break anything.
Then use a star driver (check your misc socket set drivers for the right size). Unscrew the two star head screws and pull this bulb holder straight off the tail light (same direction as screws). Replace the bulb and put back together in reverse.
SOURCE: where is the oil filter on a 2007 dodge nitro v6
You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.
For more info on Dodge Nitro, visit the forum at
http://www.dodge-nitro.com/dodge-nitro/
SOURCE: I need a serpentine Belt diagram for a 2007 Dodge
This link should help you. Also you vehicle came from the factory with a diagram under the hood somewhere.
http://www.aa1car.com/library/serpentine_belt.htm
SOURCE: i need a photo for
Check this image...
Serpentine belt routing 3.7
Hope helps (remember to rate this answer).
1,568 views
Usually answered in minutes!
×