Where is the main relay located? Is their two rotors?

The main relay is usually located on the drivers side under the dash. It is usually brown, rectangle shape about half the size of a stick of butter, with about an 8 pin connector. Let me know if this helps.

The fuel pump is relayed by the Main Relay, on your 92 Accord. It is located up under the dash, above the driver's left foot location. Search on this site for Accord main relay diagrams and posts.

main relay for the no start when its hot.... and cap,rotor, wires for the no start when its wet.....

replace main relay this will keep it from starting when hot out. 1994 honda accord, have a good day !!

You forgot to replace the whole car or engine!

The Main relay on your vehicle is defective. When the relay is operating while the engine is started and running, it gets hot. Add the hot weather to the relay and they break inside. The relay is located on the side firewall driverside above the left kick plate inside the car,and is secured with a 10mm hex cap screw (bolt). Replace this relay, and your vehicle should start.
It looks like this;

It's going to be your main relay, located under the dash on the drives side, turn key on and off, you will he a clicking sound, that the main relay control your power to you computer also.

Are you aware that there is also a problem with the ignition starter switches in this model?

Check out your "fuel cut-off switch" located by the windshield washer tank behind the driver's side wheel-well panel in the trunk. It's a small box with a push-button at the top. If the button is "soft" when you push it, that's probably your problem. Replace the unit by removing the washer fluid tank first. The box simply plugs in. Probably about $ 100. I replaced three in my Probe. They rot out, and the car simple dies.

The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release.

rate this solution fixya.

Diagram below:-

Acura Main Relay location and removal procedures.
Integra EFI Main Relay for:

• Honda Civic/CRX/del Sol 1984-1995
• 1986-89 INTEGRA
• 1990-93 INTEGRA #39400-SH3-003 RELAY (RZ-0063)
• 1986-90 LEGEND #39400-SH3-003 RELAY (RZ-0063) (RZ-0046)
• 1991-93 LEGEND (rz-0105)
• VIGOR (behind the left front kick panel)

The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release. The First generation Legend main relay location is between the steering column and the fuse box. It's deep in there. There was a little difficulty drawing the relay so it's actually very deep in there. There is a device (a relay) blocking the main relay. You will need to remove it to get a view of the main relay. The removal procedure is the about the same as the Accord's procedure.


Legend, 96-98 Acura TL main relay Acura Integra 98-01 main relay location:

Locating the main relay using your ears and fingers:
Steps:

1. Turn the ignition to ON. You should hear two clicks (a thousand of a second apart) under the left or right side of the dash board. One click is for the ECU/Injectors the other is for the fuel pump. At this moment the check engine light should come on.
2. Listen carefully at the moment the clicks engage (usually somewhere underneath the dashboard.) Reach in and touch the main relay.
3. 2 seconds later you should feel a click if the main relay is at least working or wait until it works. At this moment the check engine light should go out.
4. Turn the ignition to start and you should feel a click, turn engine off you should feel another click.
5. Most main relays should have seven terminals. Please check if the location is already listed below.

How do I get the main relay out?
Steps: See four ways below so you can get it out. First you have to reach high up in there and do all this with one hand and a flashlight.
A. Unbolt the bolt using a 10mm socket (picture A) or
Ab. Unclip the clip from the steel tab and slide it apart (picture A) or
B. Separate the steel tab from the plastic case (picture B) with a large flat screw driver jam and twist between the plastic case and the tab or
C. Disconnect the negative battery terminal. Unclip two clips I pointed with two arrows (picture C, or below) with a small flat head screw driver or with a strong thumb and then yank it out (D.) This is the preferred choice by many. Mechanics prefer choice A and maybe B. See detailed relay circuit photo.

check your main relay it may be in default it is the signal that sends the gas pump is located below the driver side dash give me the new