SOURCE: 93 mazda protege clutch repair tips needed
to take out your drive shafts you first need to drain oil from gearbox.plug is on the bottom of box.when this is done remove wheels..take off your disc caliper (2 bolts).tie them up out of way.remove disc rotor(should just slide off).then you need to remove split pins from your steering rack(tierod).. 2 bolts where the part bolts to the strut.next is at base (lower control arm).you will see a bolt and nut(this will be tight to get out use a soft punch like copper or brass shaft to knock bolt out.dont damage thread).to replace this you have to make sure it sits in the right place or you will damage thread when you fit the bolt...when all this is done the hard part comes.the drive shaft is very tight in the gearbox due to a spring type circlip on the axle shaft.you have to wrench the shaft towards you to free it .some times you may have to get a very solid big flat screwdriver in between the gearbox and shaft to loosen past the clip.when it is free ,just slide out.when you have done what you need to do.assembly is just reversing whatyou have just done . to fill gearbox up you have to take out the speedo cable and speedo drive from the gearbox (at back off motor,1 little bolt).top up .you have a mark on the drive to tell you the level.hope this helps (have fun)
SOURCE: how do i remove rear brake drums on 1997 mazda protege
There may be two screws on the face of the drum that you have to remove. If so, you will do this using an impact screwdriver. After the screws are removed, parking brake off, tap on the outside of the drum and pull it off.
Please remember to rate this answer.
SOURCE: where is drain plug for transmission on 1997 mazda protege
normally you have to take all the bolts off from around the pan and you can try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
SOURCE: 1997 Mazda protege LX 1.5 automatic transmission
You are going to need a transmission shop. Mazdas do not always throw codes. You have an early OBD transmission, which do not send out many codes.
SOURCE: fuse box diagram for 1997 mazda protege
Idont have register, but you can find 2002-present models (Login required).
Hope helped (remember rated this post) Good luck.
133 views
Usually answered in minutes!
×