The main lug.?
this is car repair 101 basics.
all this in books , online and on youtube.
must we repeat that which super basics?
first remove the battery neg lug, so you dont blow up the battery and eat acid in face.
the go to walfart.
walk to rear (heck take whole car and let them do it>? or nuttn)
see that battery rack
there.
see to the left. that lugs.
buy one and put it on.
SOURCE: I Need step by step
THE EASIEST WAY IS TO GO TO YOUR LOCAL AUTO RETAILER AND BUY THE REPAIR MANUAL FOR THAT VEHICLE. PAY A BODYSHOP FOR THE INSTRUCTION
SOURCE: Radiator flush for my suzuki forenza.
For the do-it-yourself kind of mechanic, there is a kit sold by Prestone that will help you back flush the system using an ordinary garden hose. Available at most any auto-parts store, Walmart & such. It has the basic instructions on the container but I'll give you an overview.
You will need a large container to catch the anti-freeze coming out, You could drain it by removing the plug at the bottom of the radiator first , or remove the lower hose & get most of it out & then just flush the remainder, back-flushing is recommended.
There is a piece that fits into the radiator caps position that helps to aim the water towards a container but sometimes you can't use it due to size restrictions & limitations on space & have to catch the fluid with a drain pan as it overflows.
You will need to install a backflush connector "T". You simply cut into one of the 2 heater hoses, preferably the return line, and install that piece using 2 hose clamps to secure it. The garden hose hooks there.
The engine should be cool, you can crack a head or block by drowning a hot engine with ice cold water.
Just turn the water on slowly, once the anti-freeze stops coming out & it's just water, remove the drain pan & recycle what anti-freeze you can. Remember, most anti-freeze is fatal to birds & animals, including large dogs & children, so clean spills or at least dilute it with water until it is not a threat.
once done, drain the system & refill with the mix you prefer for your area, usually not less than a 50/50.
good luck.
SOURCE: Where is the crankshaft position
Hello Aldozer.
It is mounted below the power steering pump and behind the AC compressor(if equipped).
Both will need to be removed to access it.
Here is a pic of the engine after they are removed.
I hope this helps you towards a good repair.
Thank you for using FixYa.
KL
SOURCE: I need the Head bolt
head torque specs for 2004 suzuki forenza are 18ft IBS then 90 degrees in sequence 3X
SOURCE: Where is throttle positioning sensor
Removal & Installation
To install:
105 views
Usually answered in minutes!
×