Most cost effective would be to splice a new plug end onto existing wire. link below shows how, press the helpful button
SOURCE: Can't find where to put transmission
Looks like they came with a fill tube that should be capped off but no dipstick the tube should be by the firewall with just a cap on it
SOURCE: Needing to locate the airbag control module '07 caliber
it is located behind the floor shifter in center console..under small piece of carpet
SOURCE: 2007 dodge caliber sxt front end making noise
problems with random check engine, gas, or abs lights going off loud noise sounds like grinding ...its your alternator..hard part to find a brand new one is $400.
SOURCE: how to change head light bulbs on a dodge caliber
Park the Dodge Caliber on a flat paved or concrete surface. Turn the steering wheel all the way to the side opposite the headlight you are replacing. In other words, if you are replacing the left headlight, turn the wheel all the way to the right. Apply the parking brake and release the hood latch.
SOURCE: how do i install a alternator for a 07 dodge
you will need to disconnect the negative battery cable at the battery, remove right front wheel, remove underbody air dam, remove accessory drive splash shield, remove the accessory drive idler pulley. Next loosen the lower mounting bolt, then loosen the a/c compressor and relocate(pull down and to the outboard side of the vehicle to make room for the alternator the come out) next uplug field circuit from alternator and the B+ terminal nut and wire. remove upper mounting bolt on the alternator and lower mounting bolt. relocate the terminal to the other side of the a/c line. Rotate alternator pulley down and slide down and out of vehicle. Yes, its a pain in the ****.
717 views
Usually answered in minutes!
×