SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport
1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery
Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.
SOURCE: 1996 Dodge caravan--dash guages flicker
In responding to rbenjami, I am not proposing the same solution for all who claim to have a similar problem because I don't believe that that is the case. When the gauges flicker periodically it may be a case of a bad body computer, which is a big deal and may be covered by warranty beyond the normal 3 yr./36k miles. For those with issues related to use of seat warmers, that is not uncommon and should lead to discontinued use.
SOURCE: 2003 dodge caravan rear door locks
Look for contacts at door jamb & door, that mate when closed.( usually round metal piece) Take a piece of fine steel wool & scrub them and see if that cures it.
SOURCE: 1996 dodge grand caravan
my manual says, 1 close doors, 2 place key in ignition & turn key between off and on position for a total of 4 times ending in the off position (do not start engine), 3 press driver side door lock button to lock doors, 4 you will hear chime when programming is completed
SOURCE: 2002 Dodge Grand Caravan Driver Door Lock/Unlock Switch
sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
http://www.dodge.com/bodybuilder/2004/docs/wd/rswd/tc.pdf
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.
142 views
Usually answered in minutes!
×