I’m having this same problem. Did you figure out what the problem was?
Sounds like your ignition switch might be worn and need replaced. It is pretty common for the glow plugs to draw quite a few amps. they just aren't usually on when the truck is running.
SOURCE: number one injector bank on 2006 dodge cummins
you'll notice on your valve cover gasket there is two connectors.. the one up front is your 1-3 the one in the rear is your 4-6... you can remove your valve cover and check the connections from the injector connectors to the
connectors on the valve cover.. check for an open.. however you could also have a fault internally in 1 of your injectors in that bank as well.. hope this info helped..
SOURCE: 2006 Dodge Ram 1500 mega cab abs and brake lights stay on
check the sensors and connections may have loosened or knocked one loose if they look ok than have truck scanned most auto stores such as auto zone/advanced auto scan for free the trouble code will narrow the problem
SOURCE: 2001.5 Dodge Ram Diesel 2500 4x4 Brake Pedal drops to floor
It sounds like you have a bad mastercylinder cause when you panic brake it doesn't have time to bleed through the valve in the cylinder but under normal braking your foot is on pedal longer in turn giving the fluid time to bypass the valve in the mastercylinder in turn the pedal going to the floor.
Testimonial: "thnx"
SOURCE: abs and park brake light came on same time
Its either the speed sensor on the rear differential or your steering wheel is all the way down pinching a wire in the harness. I have had both problems. Raise the steering wheel and if that does not fix it then its the speed sensor(might be called something else) but it is on the rear diff.
1,245 views
Usually answered in minutes!
×