My 2004 s type turns over but won't start. I changed the battery already. Also, where is the fuse located for the Crank Sensor?

Does a scanner communicate with the PCM / ECM engine computer ? any code's ? Does the engine have compression ? In time ? Timing chain etc....

sounds like a crank sensor to me it is located on the bell housing of the transmission on drivers side near the top

Check your PCM fuse

which crank sensor do you replaced ? the P0336 means P0336 Crankshaft Position Sensor A Circuit Range/Performance.

________________
autel maxidas 708

check your battery, starter or ignition.
___________

allscanner its3

many things will cause no start problems could have faulty ignition switch.use test light see if power going to starter if not check ignition fuse to starter.if power going to starter, more likely starter solenoid or starter faulty.if ignition fuse okay and starter and solenoid okay still no start problem could be in the ignition switch or inhibitor switch faulty.code scan for faulty theft security system which will also cause no start conditions.

check for your cam sensor or crank sensor .

No.
The crank sensor tells the computer when number one cylinder is at top dead center to find the timing for the spark plugs.
If the engine will not crank with the starter, the starter, key switch, battery or cables could be faulty.
Some of these items could also cause it not to start.
If the engine is stuck you won't be able to turn it at all.

check your ignition fuse and relay fuse.also check your master fuses located on the fire wall they are the ones that run from your nattery to your maine master fuse.follow the battery cable the red one all the way to the fire wall and from there it gos to the starter you may have burned thoses fuses out remove the black fuse cover

look everyone !!! i am not the only one who has this problem , but I found the answer on my own.... iI hope this can help others . If you have to replace a neon engine you must do these thing if you want it to start.
<br>
Lower vehicle and perform camshaft and
crankshaft timing relearn procedure as follows:
² Connect the DRB scan tool to the data link
(diagnostic) connector. This connector is located in
the passenger compartment; at the lower edge of
instrument panel; near the steering column.
² Turn the ignition switch on and access the “miscellaneous”
screen.
² Select “re-learn cam/crank” option and follow
directions on DRB screen

Most people don't have access to this scanner <but it must be done> I used a snap-on cost 3000 but have the reset feature

Thanks you all for your help.