Chrysler
SOURCE: removing the 2.7 engine from 2001 sebring sedan?
ok heres the simple version its alot of work
remove hood put someplace safe
disconnect all wireing and mark off with masking tape and marker
****** you need car lift ******
remove all plastic part molding from engine
find the engine hoist holes for chain to hook to
this is a unibodi design so the whole front chassis drops down
unbolt the chassis make sure to have the chasis blocked and stable
lift car while chasis stays on floor engine tranny and every thing inside hood comes down on the unibody this is how you remove an engine from a sebring
or you take to the dealer spend the doe cause you got a nice car and have it done right
SOURCE: Is the 2001 Ford escort ZX2 L4-2.0L DOHC engine
All of Ford's belt driven engines are non-interference with the exception of the 3.0L villager which was really a nissan.
SOURCE: worn rear wheel bearing, 2004 chrysler sebring,
REMOVE THE REAR DRUM OR ROTOR,REMOVE DUST CAP FROM BEARING..REMOVE RETAINING NUT..HUB/BEARING WILL SLIDE OFF SPINDLE..REVERSE PROCEDURE TO INSTALL..I HOPE THIS HELPS
SOURCE: How do I replace the window motor in my car?
take the door panel off...should be 3 bolts holding motor inplace and wiring to unplug...make sure the window is up when attempting ...its not as difficult as it seems thanks and have a good day
SOURCE: Does my 2001 3.3L V6 EFI Nissan Xterra have a non
It's has a timing belt, also it's an interference engine, if belt goes bad it will bent valve's .
646 views
Usually answered in minutes!
×