Reverse and drive ?
Could be a torque converter issue.
SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: 2001 dodge ram 1500 v8 spark plug wire diagram
the firing order is 1 8 4 3 6 5 7 2 clockwise around the cap
SOURCE: 1995 dodge ram 1500 V8
hi, you should find a serp. belt routing diagram on the cross member that supports your radiator. if not- disconnect neg batt terminal for safety. you'll need a long breaker bar metric. as most, if not all fasteners on your ram are in metric. cant remember right size socket, but just go through your metric set and "eyeball"it. once you have the proper socket-detention the belt by pulling breaker bar clockwise. remove old belt. it maybe useful to take a picture of how your old belt is routed with a camera equipped cell phone (if it is still on) so that if you get into trouble, you can look at the picture as a reference point. new serpentine belt install--insert new belt over the cooling fan route under crank pulley-over fan pulley, around p/s pump pulley,up and around a/c comp pulley, under idler pulley, over alternator pulley and finally around tensioner pulley. pull breaker bar clockwise to slip belt past and onto the tensioner pulley. release tension on tensioner. be sure to check tensioner indexing marks located on the tensioner arm this is to make sure the new belt is installed properly. reconnect neg batt cable to terminal-remove any hand tools from engine bay, start engine and observe belt operation. hope this helps!
SOURCE: 1998 dodge ram 1500 v85.2 towing capacity?
according to the owners amnual the max towing weight for a 1999 ram 1500 quad cab wit automatic transmission is 7600 lb.
with either 5.2 or 5.9 v8. for a reg cab it is 8000 lb.
SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171
This code means that system to lean, bank 1.
some of the possible causes to make this code set are
1. intake or exhaust leak,
2. problem with the air system.
3. MAF (Mass Air Flow sensor)VAF sensor (Volume air flow sensor)
4. fuel pressure/pump
5. injector(s)
6. HO2S (Oxygen sensor)
296 views
Usually answered in minutes!
×