SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
SOURCE: Where is the PCM located on a 2002 chrysler
The PCM (Powertrain Control Module) is the aluminum box with fins that is behind the left headlight and toward the engine a bit. It's about 12" long 6" high and 2" thick and runs lenghwise from front to back. The box right behind the headlight that is about 6x6x2 and runs side to side, is the TCM ( Transmission control Module).
SOURCE: 2002 chrysler sebring 2.4l leaking water is it water pump
Those engines are noted for having bad head gaskets so I would look into having your head gasket cheked for leaks.If you look you should see the seem where the head(which is where the manifolds bolt to and the spark plugs screw into and the cams are on top)meets the block and check for any wet spots on this seem front and back.If it is leaking bad enough you should be able to run the car and let it get to operating temp.and have water presure in the engine then it will be easier to locate the leak.I would also check the oil for any creamy looking substance on the oil fill cap or the oil dip stick which would also indicate a head gasket problem.
SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan
Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!
SOURCE: where is the starter located on 2002 Chrysler
Starter is under the hood 100% there! u will not be able to see it from the top! it locates (if its V6 2.7L) on the front of engine, under the hood u will see exhaust pipe with a sensor closer to the radiator. to replace it u need to lift car and start from the bottom, take off "Y" shaped pipe, from the top cover of the exhaust pipes and u will see what to do then. ( it took me to change starter about 3 hours) but u can do it in 2 hours.
151 views
Usually answered in minutes!
×