Location of transmission speed sensor on 3000gt

Does your versa have automatic transmission or CVT transaxle Makes a difference

The output speed sensor on a 2014 Ford F150 XLT is typically located on the transmission tailshaft or the rear of the transmission case. It is used to measure the rotational speed of the transmission output shaft and send a signal to the vehicle's powertrain control module (PCM) indicating the transmission gear ratio.
I would recommend checking the vehicle's service manual for a more specific location and a diagram of the sensor, as the location and installation may vary depending on the specific transmission model and options your Ford F150 XLT has.
The output speed sensor is typically a small, cylindrical sensor that is mounted to the transmission case. It is connected to the PCM via a harness and may be located near the transmission oil pan or near the output shaft.
If you're unsure of its location or have trouble finding it, a professional mechanic will be able to locate and diagnose any issues with the output speed sensor.

2005 kia optima: my input shaft speed sensor located ...

https://www.justanswer.com > Car Questions
Jul 27, 2010 - The input shaft speed sensor is located on top of the transmission Just under the Air Filter. So you will have to remove the Air Filter and you ...
1 answer · Top answer: Hi thank you for your question hope this helps. The input shaft speed sensor.

Videos as well

https://www.google.com/search?q=2005+Kia+Sedona+Location+of+input+turbine+speed+sensor+for+automatic+transmission

..

The Ford Freestyle transmission speed sensor location is driver side of the transmission, near the rear of the unit. The transmission is one of the most important parts of the vehicle. You will come into problems at some point. You may experience shudders.

Where is the ford freestyle transmission speed sensor located?

The transmission sensor or speed sensor is located in most vehicle located on the transmission case.These speed sensors are driven by a gear located on the output shaft. The speed sensor's driven gear can be either machined or fastened by a clip. The driven gear is made by plastic to make it softer than the drive gear. It's located on the end of the vehicle speed sensor.

Welcome To FixYa.com,

Regards, Lee Davidian

A 4'''' Thumbs up is appreciated so please take the time to rate me. Testimonials are accepted,

Thank you, Lee Davidian

With reverse, 5th and 6th not available, I would suspect one or more of the shift cables are not properly connected, or anchored on the transmission. Are you sure that you got a 6 speed VR4 and not the 3000 GT 5 speed?

hi , their is two different speed sensors on your vehicle one is the input speed sensor which is inside the transmission and the transmission will have to be removed to replace it the other one s the output speed sensor is located directly above the passenger side trans-axle shaft. your input sensor is the sensor which tells the transmission when to shift and the output speed sensor tells the speedometer what it should display and both those parts are fairly cheap they are around 15-25 dollars but just remember if your input speed sensor is bad it is gonna cost you a minimum of 1000 dollars to have a mechanic fix as the transmission needs to be removed hope this is what you needed

There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix

have you contacted reputable transmission companies that deal in 3000gt Getrag transmissions.
try Kormex or some others from this list
http://www.stealth316.com/1-links-t.htm#j7