Https://www.amayama.com/en/search/?q=2212027000
Op for 04 Hyundai Santa Fe en... on Google
2001?2006 Hyundai Sant...
$44.23
PartsGeek.com
Fel?Pro ES72211: Fel...
$36.97
Summit Racin...
Fel?Pro ES72211 Cyli...
$43.29
Jet.com
Felpro 2005 Hyundai Sant...
$52.28
Google Trusted StoreAutoParts...
Hyundai Santa Fe Screw ? tap...
$0.44
Jim Ellis Hyu...
Search Results
SOURCE: Hi I need torque specs for b5 dohc(cylinder head job)
the pdf manual says it is 10 - 13 ft lbs
from my research it is 75 ft lbs
I hope I am right cus I just set my head at that :(
before i got the pdf file!
havent started it yet though
SOURCE: hyundai elantra 1.6GLS J2 torque settings
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
SOURCE: need torque specs for connecting rod and main
Torque in two to three stages.
Connecting rods are 24-26 lb.ft.
Main bearing caps are 41-44 lb.ft.
Hope this helps,Chuck
Testimonial: "Thanks for the help Chuck"
SOURCE: Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
741 views
Usually answered in minutes!
×