How to reset the check tire pressure indicator

If using the driver information center/dic, press and release info button until tire learn message is indicated.Depress and hold set/reset button until two horn chirps are sounded indicating learn mode has been activated, front left turn signal will be illuminated. Starting at the left front tire, increase/decrease the air pressure for 8 to 10 seconds and wait for the horn chirp. It may take 30 seconds for the horn to chirp. When horn chirp has sounded the sensor information is learned, then the turn signal for next location will be illuminated and so on. When all sensors have learned the horn will double chirp. Turn key to off position to exit learn mode. Adjust all tire pressures to recommended pressures. System will complete calibration process as vehicle is driven.
Knowing the model would help, the info above covers several chevy models, but, not all.

The TPS sensor may be dirty or defective...be sure all tires are above 33 psi...

With and without "Mesage Center" respectively (pretty sure)

With the engine on...

Push "Setup" button, until your driver display says something like "Press Reset for system check".

Then push Reset. The system check will start, rotating through a series of checks.

About the fifth or sixth check will be the tire pressure. The system will sound the tone (same one that starts w/the light) and It'll say something like "Check Tires Pressure" on that moment press and hold for 3 or 4 seconds Reset. When you release the Reset button It'll show "Hold Reset if tires are OK". While that's up, hold the Reset button. After 3 or 4 seconds, the tire warning light will blink 2 or 3 times and then will stop .You need to be ready for it, because you don't get very long to release.

How to reset the low tire pressure warning if the vehicle does not have the "Message Center"

Turn the ignition to the ON position,
depress and Trip/odometer button (located in the instrument cluster) until "TIRE RESET" or "CHECK TIRE AND RESET" is displayed in the odometer display window.
Once "TIRE RESET" or "CHECK TIRE AND RESET" is displayed, press and hold the button for three seconds.
The low tire warning indicator light will flash three times as the low tire warning system begins to initialize.

This information is in the Owners Manual

Hope it helps

Press the message center SETUP button until the message center displays "Rest for System check". The message center will display "Hold reset to relearn". Hold the reset button. It will cycle through all of its indicators and when it gets to the tire indicator test it will ask you if you want to reset the indicator. Hold the reset button to reset the indicator.

It will not go off until it has been reset.

There are 4 key ignition settings: Off, Acc, On, Start Turn key to the On position, quickly press the gas pedal 3 times, then turn key clockwise to Start position and actually start the car. You'll hear it chime at you and the change oil indicator light will flash and disappear.

The tire light....Have you checked all your tires for prper air pressure? including the spare? If they all have the maunfactures recomended PSI. Remove the negitive post from the battery for 20 min. to rest puter. If that dont work you have a faulty TPMS on a tire need a new one. Hope this helps

The " Check Engine" pertains to the computer sysytem informing you of a failure code stored. In order to clear , the problem must first be solved, and then clear the computer. Tire prssure warning light advises of low air pressure in any of your tires. Check tire pressures. A fault in a particular tire valve sensor may also indicate a fault if all pressure are up to spec

It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

Vehicles Without Message Center To reset the system, press and hold the odometer reset button and wait for the "TIRE PRESSURE SET" light to illuminate. Continue to press the button for 3 seconds, then release. After 3 seconds, the low tire pressure warning lamp will flash 3 times, indicating that the low tire warning system reset procedure is complete.
Vehicles With Message Center To reset the system, press and hold the SETUP button and wait for the message center to display "REST FOR SYSTEM CHECK". Then press the RESET button and wait for the message center to display "HOLD RESET TO RELEARN". Press and hold the RESET button for 3 seconds. The message "HOLD RESET TO RELEARN" and the low tire warning lamp will flash 3 times, indicating the reset procedure is complete.

Make sure you check the spare tire too; had this problem on another model and the dealer said it was the spare which is also monitored.  Good news in case you need it one day.

From the manual: First find the reset button, located below the handbrake (emergency brake) lever. The button has an "exclamation mark in a tyre" symbol.

Make sure the pressures in all tyres are what you want them to be. 35psi all 'round is good for sporty driving.

Engine off. Turn ignition to the second position (ON) but don't start the engine.

Keep the re-set button pressed until the flat tyre indicator light on the dashboard COMES ON for several seconds.

Start the engine, and drive the car normally for several minutes. This will re-set the indicator to whatever pressures you have in the tyres. Hope this helps!!