- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your particular actuator will be a different one than they found.
They're all a absolute pain to get at because they can be well buried in the dash. I would start looking under the dash on the passenger side, that's where most of the air control is. Cannot get any air from dash vents while defrost and floor vents work fine...
There is actually two blend door actuator that control the opening and closing of your vents. Ine is located under the drivers side dash board. The is on the passengers side. Both are electric and I didnt have the money to replace them so i removed them and turned it with a pliers to allow heat to come out of bothe sides of the vent. Then come summer flip the little bar back the other way to A/C Hope this helps God blessss
i'd think that the vent adjuster knob/slider is not working correctly strip out the heater panel around the control knobs and check the vent direction is working properly either stiff operation so a little wd40 on the cable would probably do the trick or some thing causing the vent itself to not move
I assume your heater setting is electric control, if so either your defrost and floor heat switch failed or wire problem.
For the air not hot, check the heat control valve on the top of the hose it should be in front of the firewall. I don't know your car is using mechanic valve or electric control valve. Anyway check there first.
Good luck.
There is a blend door acuator which moves when u change your settings. Its a electric motor. Down under dash, Will need a mech and a heating and cooling diagram to find where the motor is,
common problem, check under dash by the gas pedal if control arms are muving went selecting from ac to heat cuz this it is the control for the vents to go from ac to heat and to defrost.
×