Www.ask.com/mfg.name/make/model/year/location/fuel/pump/relay/
you can go to you local auto part store ask for help.
go to www.youtube.com/where-locate-fuel-pump-relay/
they may not have the model but similar cars or try putting the car info. in the statement question your asking.
--------------------------------------------------------------------------
it mite be on the firewall under the hood, in the fuse box area, where the fuel pump location, and inside the gas tank.
SOURCE: fuel pump relay location on a 1990 mercury grand marquis.
check the fuse .if the fuel pump was bad you blew the fuse . there is a inertia switch in the trunk or under the dash you could check . push the red button to reset relay should be under the hood in the fuse box check your book if you have one.
SOURCE: how to change the fuel pump on a 1994 Mitsubishi Montero LS 3L V6
just for you REMOVAL & INSTALLATION
See Figures 1 and 2
WARNING
In almost every case, replacing the Mitsubishi electric fuel pump requires removal of the fuel tank. Please refer to the fuel tank removal and installation procedure at the end of this section.
The fuel pump may still contain liquid fuel. Drain it into a suitable container with an airtight lid before performing any tests or inspections.
To install:
WARNING
Take great care when connecting the threaded high pressure lines. Start the threads by hand, then, while holding the hose side to keep it from turning, tighten the flare nut to 27 ft. lbs. (37 Nm).
Fig. 1: Components of the fuel pump and fuel tank
Fig. 2: Components of the fuel pump-all models similarTESTING
When diagnosing engine problems, particularly a "no start" condition, the fuel pump function should be checked. Because of the difficulty in reaching the fuel pump connections, Mitsubishi automobiles have a conveniently located test connector under the hood. V6 Monteros have the connector taped to a wiring harness inside the right front kick panel, near the ECM and relays.
This connector bypasses all of the controls in the system (ignition switch, pump relay, etc.) and sends voltage directly to the pump. When power is applied to the pump you should be able to hear it running, although the in-tank pumps require you remove the fuel filler cap and listen at the filler.
To use the test connector, make certain the ignition is OFF. Great damage may be caused if the system is tested with the key on. Locate the test connector in the engine compartment (on later Monteros it is located under the right-hand side of the dashboard)-it is generally on a short lead out of a wiring harness and looks like a plug that isn't connected to anything. Once found, use a jumper wire to connect the test terminal to the positive battery terminal. Listen for the fuel pump; if it runs, you know the pump motor is good. While the pump is running, gently squeeze one of the fuel lines and confirm that the pump is delivering fuel pressure. If it does not run, the pump itself is most likely defective OR the connector to the pump is faulty.
When the pump is removed from the tank, it may be checked by applying battery voltage (+) to the connector and grounding the housing. Only run the pump for one or two seconds during this test; the pump can be damaged by running without liquid.
CAUTION
Make certain the pump has been drained of residual fuel and is free of fuel vapors. Connecting and removing the test leads will cause sparks which can ignite any vapor in the area.
SOURCE: fuel pump relay location 1990 chevy subburn
One of the easiest ways is to listen for pump to cycle in tank "HUM" when someone cycles key to on. If you hear "Hum" pump is getting power. The other would be to swap it out with another in that area, with same # on it. Under hood, passenger side, on firewall usually. Should be at least one more relay there with same #. There are so many ways that manufacturers recommend for different vehicles, this is usually the easiest. If I can't test for power in & out of relay when key on, I'll go direct to tank sender & check for power there to be sure.
SOURCE: location of fuel pump relay (1990 hyundai sonata)
The fuse box is located low on the left side of the dashboard behind a cover, or at the left side kick panel, behind a cover.
Relay Box
-is located under the left side of the dash as well.
SOURCE: fuel pump NOT working ,fuel pump is OK,but no voltage
Check the voltage with someone cranking the engine. The fuel pump relay is incorperated in the FI relay located under right center of dash. It is a metal relay usually bolted to the floor near the ecm. Double check all the fuses inside and out
843 views
Usually answered in minutes!
×