SOURCE: How do I remove the spare tire from my Mercury Villager GS
Chances are the tire has "stuck" itself to the bottom of the frame of the vehicle. This happens when a new tire comes into contact with a clean metal surface and remains there under pressure for a period of time.
If you've unscrewed the holder, and can see that the mechanism is loose from the tire, then use your foot or a 2 x 4 or pipe or something and try to wedge/lever against the tire to break it loose. Make sure you arm, leg, foot, or had is not under the tire as it will likely fall to the ground, and those things are heavy.
SOURCE: where is ecm box located on 99 tracer mercury
It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws
SOURCE: where is a knock sensor for 1998 Mercury Villager located?
Here is a image of it's location, I hope it helps.
SOURCE: Where is the wiper delay control module located on
the module is located under drivers side dash right of the steering column. it is gray plasticmodule, the most common problem with these modules is soldering on the board. If you resolder these points the module should work for you.
SOURCE: Code reader knock sensor where is it located
According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.
1,343 views
Usually answered in minutes!
×