1997. where is the PCM located? - Tracker Geo Cars & Trucks

PCM

https://www.justanswer.com/mercury/4pxfd-cougar-how-replace-remove-pcm-1997-mercuery-cougar.html

ECU

https://www.cargurus.ca/Cars/Discussion-t7829_ds555855

https://www.google.com/search?q=1995+Mercury+Cougar+XR7+PCM+ECM+location

..

it is located on the back on the fire wall

The 1997 Ford explorer does not have separate Transmission Control Module, the transmission is controlled by PCM

It's located under the hood... and is a bit of a nightmare to replace. Remove the coolant tank and PCM. Good luck.

The ignition and timing are controlled by the PCM computer.

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

Notice the fuse description that sais IG-COIL 15amp. This fuse runs the coils and the PCM as you will notice the PCM is the last item listed in this curcuit.

The Powertrain Control Module (PCM) is located behind the right hand side of the glove box attached to the bottom right hand side.

Hello Rippgut.
The PCM is mounted in the console.
The park brake and shifter console needs to be removed to access it.
Also the 4 screws that hold down the shifter need to be removed.

I hope your repair goes well.
Thank you for using FixYa.
KL

Removal & Installation

1. Disconnect the negative battery cable.
   
2. Remove the coolant reserve tank and disengage the three electrical connectors from the PCM.
   
3. Remove the three PCM mounting bolts and carefully remove the PCM.
   
4. Installation is the reverse of removal.
   

I don't think the PCM is your problem, is the check engine light on? It could be you idle air control motor this is located on the throttle body, but because this happens while driving I am thinking you will need to replace your crank shaft position sensor it is located on the transmissinon bell housing it is very hard to replace without the correct tools. If the check engine light is on take it to a local auto parts store and ask if they can check the check engine codes for you they usally will do this for free.