- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
General anti-theft devices are connected with the original car ignition switch wiring harness on the firing line first connected to the anti-theft device, drawing a line of fire from the anti-theft device into the ignition switch. You can the combination switch the first guard removed, and then find the ignition switch, disconnect the two lines you will be connected with the anti-theft device, FireWire directly to the original vehicle wiring harness plug connected to the ignition switch on, you can normally start.
You can't remove the device as you call it, you can bypass the key sensor only. As far as the failed smog test goes that can one of about a dozer problems, some as simple as an oil and filter change. To bypass the VATS passkey security system follow this link.
It's possible that you will need assistance from the manufacturer of the Anti Theft device. They may have tto reset the system, as an Anti theft device, any thing construed as 'tampering' with the car, or the device may cause it to shut down, and would need tech support from the manufacturer.
the shop that told you they ripped it out only ripped you off unless they removed some aftermarket alarm system i,m a gm mechanic and if you remove the factory anti-theft on a 2003 olds alero it will not run ever again until re-installed make sure your battery is charged good turn igntion switch to run position but do not try to start security light should be flashing let car sit with switch on and light flashing for ten minutes light should stop flashing now start your car this is how to reset anti-theft was that worth $400.00 and again why let a bussiness named brakemax look at a no start condition keep on and you will be BROKE to the max HOPE THIS HELPS AND STAY AWAY FROM THEM YOUR FRIEND @ HELPMAX
you have one on the inside of each wheel.
SECTION 206-09A: Anti-Lock Control
2002 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION
Front Wheel Speed Sensor
Material
Item
Specification
RTV Silicone Sealant FSTZ-19G204-AB (Canada CXC-114A)
NAVSTR Sealer Removal and Installation
Raise and support the vehicle. For additional information, refer to Section 100-02 .
Position the inner splash shield aside.
Remove the pin-type retainers.
Position the inner splash shield aside.
Disconnect the anti-lock brake sensor electrical connector.
Remove the anti-lock brake sensor harness from the brake hose clips.
Remove the anti-lock brake sensor.
Remove the anti-lock brake sensor clip.
Remove the anti-lock brake sensor.
NOTE: Make sure the anti-lock brake sensor is fully seated before installation of the new clip. To install, reverse the removal procedure.
Apply a 2.5 mm (0.1 in) bead of silicone sealant to the outside diameter of the anti-lock brake sensor.
-------------------------------------------------------------------------
Rear Wheel Speed Sensor
Removal and Installation
Raise and support the vehicle. For additional information, refer to Section 100-02 .
Disconnect the rear anti-lock brake sensor electrical connector.
Remove the rear anti-lock brake sensor harness from the control arm clips.
NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal. Remove the rear anti-lock brake sensor.
In my case the solution was a fuse on the passenger side inside fuse box. It is not listed as a fuse for the radio but it is none the less. If your cigarette lighter isn't working either its the fuse. On my 2004 it was fuse # 9 a 15A fuse.
×