Question about Pontiac Cars & Trucks
Break-in qire, bad switch
Posted on Sep 28, 2015
Motor could be gone.
Posted on Sep 28, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If the 2005 Montana is similar to the 2001 Montana, I have a solution. First you'll need a hexagonal wrench (the 6-sided L-shaped wrench). The tail light assembly is held on by two screws. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I also had to use a conventional adjustable wrench to get the leverage to turn the hexagonal wrench, because the screws were in there pretty tight. Once you remove the two screws, the whole tail light assembly should come off. Mine required a little force and I had to play with it a bit, but it came off without a lot of work. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Once you get the tail light assembly off, you'll have to take apart the assembly that actually holds the lights. No tools should be required. It's held on by four plastic catches. Just undo the catches (easier said than done, but still not too tough) and it comes apart. Then you can pop out the old light and pop in the new light. Then re-assemble. For me, it went back together much easier than it came apart.
Posted on Jan 03, 2009
no that is only the older rear calipers on gm and others. the fronts do not have that style caliper and sound like the calipers are frozen and may be way your changing the pads. try opening the bleeder screw and then compressing them if they go then you need need brake hoses and if not you need calipers. god luck man
Posted on Dec 13, 2009
SOURCE: Pontiac Montana SV6
For instructions on how to program remotes and keys check website below, I use these and they are usually very accurate. This website does state that on your vehicle, special equipment is needed to program a key fob, as there is no onboard programming for it. However, there are programming instructions for transponder keys.
Posted on Feb 15, 2010
SOURCE: 2006 Pontiac Montana SV6 Front
First off make sure the thermostat settings are set the same on the control panel for both front and rear units if thats ok it could b a few possibilities. 1 pluged heater core in rear 2 blocked heater hose try looking into these and see if it helps any
Posted on Dec 10, 2010
Your electric fan should only kick on when the van tells it to. The way this is accomplished is by a sensor. I dont know where it is located on your vehicle specifically, but they are sometimes located in the radiator (common for aftermarket fan kits).
Posted on May 05, 2012
Tips for a great answer:
Apr 02, 2015 | 2003 Pontiac Vibe
Apr 14, 2014 | Volkswagen GT Cars & Trucks
Mar 03, 2013 | 2003 Saturn VUE
Jan 05, 2013 | 1994 Isuzu Trooper
Oct 29, 2012 | Toyota Cars & Trucks
Aug 01, 2011 | 2006 Hyundai Sonata
May 24, 2009 | 2006 Toyota Highlander
Apr 19, 2009 | 2008 Dodge Charger
Nov 25, 2008 | 2004 Jeep Grand Cherokee
105 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: