Question about Cars & Trucks

2 Answers

I checked my relays and fuses all is good why is my quarter panel windows stop working?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,326 Answers

Bad switch

Posted on Sep 28, 2015

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 6,157 Answers

Check the motor.

Posted on Sep 28, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Tech jk

Tech jk

  • 102 Answers

SOURCE: 2002 Alero defogger

A common thing to fial on these- assumning the grid is ok, and wires are still attched to grid, is the rear def / antenna module. It is behind rt. rear quarter trim panel. The modules burn up, and also melt the connector. the module and connector would need to be replaced.

Posted on Jan 04, 2009

Anonymous

  • 2 Answers

SOURCE: electirc window don't work 1987 325i

Chances Are Your Motor Just Went Bad Take It To A BMW Shop They Can Check It For You.

Posted on Feb 08, 2009

rickyrt441

Richard Hale

  • 4399 Answers

SOURCE: 1998 ford contour heater blower

It is probably the blower itself. If the fuse and relay are good, I would say it is.

Posted on Feb 23, 2011

Autotroubles

Sam Akber

  • 1105 Answers

SOURCE: my 2003 elantra all 4 windows stopped working.

Wiggle the wires going into the door from the pillar where the door hinges are while trying to put the window up or down if nothing happens then change the master switch.

Posted on Feb 28, 2011

Sandpiper99

Sand Piper

  • 71 Answers

SOURCE: Power windows on ford explorer

The main reason for this concern, especially if the door is used quite often and/or the vehicle has higher mileage is a break in the wiring going from the drivers door to the body. If you access this area by pulling the protective rubber back, shine a flashlight on these wires and look for a break (open circuit). look for shiny spots from the open copper wire. The stress from the door opening and closing is what causes the break and often you will find more than one broken wire. It will usually be a heavier gauge wire that doesn't flex as easily. Good luck, if you need more info, please ask.

Posted on Apr 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Relay location for moon roof and power windows


These aren't relays or fuses. They are circuit breakers. About an inch long and quarter inch wide, with a metal case. The rarely go bad. I don't know exactly where yours is, but they are always in the dash fuse panel.

May 12, 2015 | 1999 Toyota Sienna

1 Answer

I have power rear vents on my 98 Villager that does not operate. I cannot locate it on the fuse box to replace so i checked each fuse and none were blown. Where is it?


go to our site for help.

your owner manual has fuse diagrams.

the qtr windows go through the power window relay. If other windows work, not likely the relay or timer module.

you need 12 volts at this wire on the overhead console switches.

  • Measure the voltage between the power rear quarter glass window regulator control switch C903 , "O/BK" and ground.

  • If no 12 v, SERVICE the "O/BK" wire between the power window relay and the power rear quarter glass window regulator control switch.
    The ower window relay is above and behind the fuse panel on the dash. 2 relays and turn signal flasher in same area. Turn signal light on to locate flasher. 2 bolts hold bracket with relays & flasher.

    gerry

    http://groups.yahoo.com/group/villagerquest/

    Jun 05, 2011 | 1998 Mercury Villager

    3 Answers

    All 4 of my power windows stopped working, and i can't find anything about a power window fuse in my manual


    Power window usually don't have a fuse but an automatically resetting breaker. If all four windows stopped working at the same time check the body control module that is what manages the power windows. Good luck.

    Mar 11, 2011 | 2002 Ford Explorer

    2 Answers

    I have a 1995 Pontiac Grand Prix SE. All four windows have been stuck in the down position since 3rd quarter 2009. I have tried replacing the fuse and the driver's side switch board without success. I...


    If the driver's side control panel has a "window lock" feature, make sure it is in the unlock position. Since you have already checked the fuse,look for a circuit breaker in the fuse box under the hood.

    Dec 30, 2010 | 1995 Pontiac Grand Prix

    1 Answer

    2001 F150 windows and radio stopped working at the same time. Checked fuses but they're all good. What gives?


    I would start with the easiest thing. On your interior fuse panel there are relays on the left side of the panel. Pull out the bottom relay and swap it with the one above it. If the windows and radio work the get a new relay. This is the accessory delay relay. It is the relay that keeps the windows and radio powered after you turn the key off until you open the door to exit.
    Hope this helps

    Apr 06, 2010 | 1997 Ford F150 Regular Cab

    1 Answer

    Electric windows do not work


    You have 2 fuse feeds in battery junction box under hood.Fuse 6(60amp) and fuse 62(30amp) and one fuse in the interior fuse panel no. 17(15amp).
    How the system works is fuse 6 feeds fuse 62 which feeds the switch side of the accessory delay relay which is located in the interior fuse panel. Fuse 17 feeds the coil side of the relay and the instrument cluster micro-processor grounds the coil side of the relay.
    When coil side of relay is grounded it creates a magnetic field which pulls the switch side closed which then lets power flow to the master window switch on the LB/BK wire on pin 6. The ground for the master switch is G400 which is the BK wire on pin 2 and G400 is located in the left rear quarter panel next to the tail lamp assembly.

    Hope this helps.

    Apr 06, 2009 | 2004 Ford Explorer

    3 Answers

    My windows


    you need to change the relay the relay number is 4A0959257 the proble is to find the relay if you find the relay posted please

    Feb 10, 2009 | 1994 Audi Cabriolet

    1 Answer

    2002 Alero defogger


    A common thing to fial on these- assumning the grid is ok, and wires are still attched to grid, is the rear def / antenna module. It is behind rt. rear quarter trim panel. The modules burn up, and also melt the connector. the module and connector would need to be replaced.

    Dec 06, 2008 | 2003 Oldsmobile Alero

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    39 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    Marvin
    Marvin

    Level 3 Expert

    85222 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    john h

    Level 3 Expert

    22486 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...