I need the torque specs for a 2003 hyundai santa fe valve cover

Question edited for a lot more clarity. Codes are P-Zero (0) not P-oh (o). Spelling also fixed.
Question moved to model category.

Here are your 3 codes with explanations and fixes. There are also a couple of videos, but one is in Spanish.

Hyundai Santa Fe P0743: Meaning, Causes, + Diagnosis

700r4transmissionhq.com https://www.700r4transmissionhq.com > p0743-hyund...
May 1, 2022 - P0743 is a generic OBD2 code that can occur in the Hyundai Santa Fe. It indicates that your ECU/TCM has found an issue with the torque ...

P0742 OBD-II Trouble Code: Torque Converter Clutch ...

YourMechanic https://www.yourmechanic.com > Articles
P0742 code means that the torque converter clutch circuit is behaving abnormally often due too dirty transmission fluid or valves.

Hyundai Santa Fe P0741 OBDII Transmission Code ...

700r4transmissionhq.com https://www.700r4transmissionhq.com > p0741-hyund...

Dec 11, 2018 - The vehicle's PCM (Powertrain Control Module) will throw the P0741 trouble code in the Santa Fe if there is a difference that is greater than ...

Wiring, schematic, electrical diagrams, error/fault codes, torque specs, parts info, assembling-disassembly procedures, engine problems etc a re basic contents of these online books they here on this website https://big-manuals.com/products/2003-hyundai-santa-fe-service-repair-manual

03 Hyundai santa fe, 2.7L engine
M6x38 mm bolts, 96--106 inch lbs.
M8x38 mm bolts, 15-19 ft lbs.
no sequence given in the specifications guide manual.

There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model
and I keep servicing and when needed repair it on my own. worth it !!!

1 MIN IS CUTTING IT CLOSE BUT YOU SHOULD BE ABLE TO MAKE IT. TORQUE SPECS SHOULD BE 14 TO 15 FOOT LBS.

Suggest to remove cover and replace gasket with Permatex Gasket Maker Silicone. Fully clean and dry apply a 1/4 bead on cover and bolt down to 20 ft lbs. go around several times to compress silicone. Let silicone cure 30 minutes then refill.

Just take a picture of it with digital camera or phone. And start removing wires and hoses until they are all out of way of cover. Then remove the bolts all way around cover and pull straight up and it will come right off. If not use a flat head screw driver to prise it off. Clean old gasket off of valvecover and engine. then put it bak together. Tighten bolts slowly, start with ones in center ov it and work your way out. Just finger tight. Then snug, then torque em down. Not too tight as if tostrip the bolt or break it off. Cause it be very expensive. also write down everywhere each wire go's unless you can remember

Open the hood, as you face the engine it is located on the L/H aft side of the forward valve cover. There is a exhause gas rubber tube going into it. It should be black in color.

This would be a faulty EGR valve.

It needs a new pruge valve. The purge valve is sticking open allowing fuel vapors into the intake manifold causing a rich hard start condition.