1998 dodge ram 1500 po132 engine light wont go off after replacing h2o sensors

Oxygen Sensors Voltage too high

P0138 DODGE - O2 sensor 1/2 Circuit highhttp://engine-codes.com/p0138_dodge.htmlForum CodePossible causes- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Rear Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks Tech notes Replacing the rear O2 Sensor bank 1 usually takes care of the problem.

There is not cut and dry solution for this code, here are the possibility's
P0132 - O2 Sensor Circuit High Voltage Bank 1 Sensor 1 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust Possible causes - Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Front Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks

The intake manifold gasket may have a leak, the unmetered air causes the lean condition.

Bank 1 is the row of cylinders on the driver side of your truck and sensor #2 is the one after the catalytic converter, closer to the back of the vehicle than the engine

The oxygen sensor is located on the exhaust manifold or directly after that on the exhaust pipe close to the engine.

Dear Madam or Sir,

the code stands for:

Heated Oxigen Sensor1, Bank 1, Heater Control - circuit low.

So the heating of the O2 Sensor is faulty, you should see a mechanic to fix it.

P0038=HO2S Heater Control Circuit High Bank 1 Sensor 2,
The oxygen sensors on your truck have an extra wire to them,they are a heated oxygen sensor,
the computer sees a problem with the heated oxygen sensor on the drivers side,before converter.
not the sensor after converter!

Will be the sensor before the catalytic convertor.

Hello grandmaster811: My name is Roger and I will help you. According to All Data repair service. You will find bank one sensor one located on the right side of the engine. They are numbered from front to rear as bank i sensor one. bank one sensor two and so on.
Please rate the quality of this answer as this is our way of knowing you received the correct answer. Pleas just ask if you need further help. Thank You for using Fix Ya. Roger