LE 4 cyl. How do I set the idle? - 1995 Toyota Camry

SOURCE: location of fuel filter on 2004 camry le 4 cylinder

ITS LOCATED ON THE FIREWALL IN THE CENTER

SOURCE: 1995 Toyota Camry 4 cylinder runs hot

Hi,

Firstly, ensure you have the required 'mixture' of coolant/water (must have required coolant).

Second, I would recommend you re-test all the cooling system sensors again (make sure they're within specifications), in case a new one is faulty.

Third, ensure the new thermostat was of the correct temp setting (they all differ), so that it opens at the required time. Most cooling systems operate within 90 - 100degC.

Fourth, make sure the radiator (and associated hoses) aren't blocked.

If your temp gauge is reading higher than normal, but NOT in the danger zone...then this can be considered normal (especially if you've replaced with new components) and nothing to be concerned about.

However, if the temp gauge IS in the danger zone....then this suggests the coolant is not flowing through the cooling system properly.

If all above components test ok, then it's possible your water pump may not be pumping enough volume.

Cheers,

Testimonial: "I appreciate your help...Maybe I should just relace the water pump, that would be the last thing that I would need to replace."

Ned C Cook

• 3433 Answers
• Posted on Nov 14, 2009

SOURCE: 1998 toyota camry le 4 cylinder How do you set the

Just make sure the timing belt is on properlyy, lining up the cam and crank in proper position to each other. The engine willstart when fully assembled because the electrical has not be altered. If it has a crank position sensor , be sure to put it back on after cleaning it and the connector.

SOURCE: Where is the neutral safety switch locayed at on

Where they all are on Toyotas - on the trans, mounted under the selector arm (the one that moves when you change gears.)

Ricky Gittins

• 715 Answers
• Posted on Jun 22, 2010

SOURCE: where is the fuel filter for 1995 toyota camry le ...

left side of engine compartment next to the air cleaner (between air filter box and firewall) bolted to inner fender