84 mustang 5.0 auto-Idle problems. runs Ok when cold , runs rough and stalls when warm. 1st year throttle body injection. was told the IAC valve needs cleaned. can`t find on car

The Idle air control valve ( IAC ) Gets dirty over time and needs cleaned from years of use. Remove and clean carbon from it, Also clean throttle body with throttle body cleaner. At most auto parts stores Advanced, Auto zone, ETC.

It can be issue with IAC( idle air control valve) causing the problem.

There are many other possibilities causing these idle issues. Engine idles rough.

There are few help links with solutions to troubleshoot such idle issues.

I suggest you refer the link below and follow its troubleshooting details:------

Click the link below:-----

Ford Expedition IAC valve replacing

http://technoanswers.blogspot.com/2012/12/ford-expedition-iac-valve-replacing.html

Bad miss at idle?

http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------

Stumbling and stalling at idle after engine rebuild?

http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html

------------

1999 Ford F-150 Idles rough and quits when gas pedal is pressed less?

http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html

---------

Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------------

Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

-----------

Cold start problem and vehicle shudder around 2500 to 3500 rpms

http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

----------

Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

-----------

GMC Sonoma Stalls and idles low

http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html

--------

GMC Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

-------------

1996 Camry intermittent engine failure while idle?

http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html

------------

Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

-----------

Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

---------

High Idle Problem

http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html

-------

While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed?

http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html

--------

High rpm in neutral? Inconsistant high RPM in neutral?

http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-------

Vehicle stumbling at idle and shows code 54?

http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html

----------

Rough idle, staling and Erratic shifting?

http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html

-----------

While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

These details will help.

Thanks.

yea id definately try cleaning ur throttle body 1st. My 03 1500hd had the exact same bad idle after my battery went bad it would die at lights unless i kept foot on gas i cleaned throttle body runs perfect now took 30min cost 8$ for cleaner at autozone and theres how to videos on you tube

Sounds pretty likely to be the iac. there should be a test for that - find it in the chiltons or haynes repair manual for your year, make model car - books found at yoru local auto parts store or local library - call ahead to be sure it is in stock
Best regards
Ck

Have you looked at your idle air control valve What is it? This is an electrically driven valve that allows additional control over the throttle at idle Where is it located? The IAC is located on or adjacent to the throttle body and consists of a small device held on by two bolts with an electrical connector.
How does it work? When the throttle is closed the throttle plate closes off any air from the intake manifold. In order to stop the engine from stalling due to lack of air the IAC opens a small valve allowing air to pass from the air ducting to the intake manifold. Often the IAC components consist of an air inlet port in the inside wall of the throttle body, immediately in front of the throttle plate, with a similar exit port behind the throttle plate. Connecting the two ports is a motor driven valve. When the valve is opened air effectively by-passes the closed throttle plate to maintain the engine at idle. The IAC also augments the throttle when additional power demands are put on the engine such as steering.


Symptoms of faulty IAC

• Poor starting: If the IAC fails to open or the inlet/exit ports are clogged shut with carbon the engine may start and then promptly stall. The engine can be kept running by pressing the accelerator. However any additional demand on the engine such as power steering or putting the car into drive (automatic) will cause the engine to stumble badly and often stall.
• Engine cut out: Even with the engine warmed when the vehicle is stationary such as at a red light the putting of the transmission into of 'drive' to pull away before the accelerator is pressed can cause the engine to stall. (Note this differs from the TPS fault which causes engine stall due to the accelerator being pressed too quickly)

How to check? Physically remove the IAC but keep the electrical connection to it. Temporarily block off the now open ports on the throttle, turn the engine on and examine the IAC valve action in response to additional loads (power steering inputs etc). The valve should open and close according to demand.

How to fix? If the motor of the IAC has failed then replace the IAC. If the valve is gummed closed by baked oil and carbon then clean it thoroughly with carburetor choke cleaner spray and a cloth. Similarly if the entry and exit ports on the throttle body to the IAC look blocked again clean them out thoroughly.

Try cleaning the throttle body and pay attention to the Idle Air Control (IAC) valve. The IAC is located by the throttle body and cleaning all the carbon build up should address the stalling issue you have. it's common when there is to much carbon build up causing the IAC to seize and not work properly causing the engine to stall. Make sure you use a can of throttle body cleaner and not Carb cleaner and just follow the instrutions on the spry can. The Carb cleaner is to corrosive to the gaskets used on the throttle body. Good luck

The problem is with the engine management system that controls the idle speed for cold starts and pretty much everything else. In the old days the problem would be the auto choke but as this is a new model its the electonics I'm afraid. You can get this sorted out at a dealer. It should still be under warrenty.

check your transmission fluid,the motor will stall when fluid is low

IAC-(Idle Air Control) module has a valve that sometimes gets dirty and sticks. Taking it off and cleaning it works sometimes, otherwise replace.
Located around throttle body. Thumb through or purchase repair maual from auto store to locate precisely.