Someone tried to steal the car drilled out ignition keys have been lost because of a ***** im family
Have a new ignition switch installed with new keys and get it programed to the car.
SOURCE: How can I bypass a anti auto theft system on my 1990 cadillac seville?
I Have A Seville 1990, When That Happen To Me I Got The Inginion
Replaced Problem Solved. What Is Happening Is Your Key Has A Chip And That Chip Is A Resister And When The Valve Is Not Sented To The Computer It Disengages the Fuel Pump And Than Tells You To Wait. Soon All That Will Happen Is You Will Get The Wait 3 Mins And It Will Never Start, A Good Locksmith Can Take Care Of This For You And That Will Save You Some Money. Cause If You Go To The Dealer Ouch They Will Hit You Up. But I Asure This Is How It Will Happen Cause It Is How It Happen To Me
And Sorry There Is No By Passing The Computer
SOURCE: Dash reads start disabled;due to theft sysytems;wait three minut
did you replace the fuse.if so try to get the alarm reset location,it could be in the stupidist place like my pathfinder you have to put the key in the tailgate and turn it to glass side and hold it for 20 seconds.and then hit the hidden reset switch under the rear carpet.
SOURCE: anti-theft system
Read your manual or take it to the dealer. It sounds like it needs reset.....if this is a factory anti theft system, only the installer may be able to help you.
SOURCE: 97 cadillac deville
you either have a bad key...did you try more than one key?
Two other things can be wrong..
1) the igintion cylnder (where ya put the key in) has samll wires that sense the pellet in the keys for your car, and often they break, and the cylnder has to be replaced.
2) the passkey module has gone bad.
Either of these problems can be fixed by any compatent mechanic that has cadillac experience.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: cadillac seville won't start
I've got an even cheaper and easier solution, instead of buying a new cylinder, find that plug and snip the orange wires going to the old cylinder.Then remove the resistor chip from the key and solder each of the the wires to each side. this will fool the car into thinking the correct resistor chip is in place, allowing you to use the original key or any copies with or without resistor chips. i just did this to my caddy and it roared to life! :)
300 views
Usually answered in minutes!
×