How do I fix lumbar support in 2002 buick park ave

SOURCE: 1997 park ave battery dies over night

I just posted my experience in another place on this site but on my 1992 PA the accessories relay stuck closed. This relay is the one that allows you to listen to the radio etc and keep things on until you open the door then all shuts off. When it is stuck closed accessories keep running until your battery drains dead. The relay was replaced and all worked great.

SOURCE: power door lock switch replacement

Remove or Disconnect

Door handle trim plate.

1. .Install or Connect
   
   
2. Electrical connector and door lock cable.
3. Trim panel by engaging hooks on backside of panel.
4. Push pin fastener in defroster duct.
5. Screw from behind lamp assembly.
6. Courtesy lamp assembly.
7. Two screws in arm rest.
8. Arm rest cover plate.
9. Door handle trim plate.

1. Trim panel. See: Doors, Hood and Trunk\Doors
2. Four tabs retaining switch.
3. Electrical connector.

1. Electrical connector.
2. Snap switch into trim panel.
3. Trim panel.

Greg Bernett

• 2993 Answers
• Posted on Jun 23, 2009

SOURCE: try to locate body control module on a 94 buick park ave

BCM --The Body Control Module is located on the right side of the vehicle and positioned under the instrument panel. In order to gain access to the module, it will be necessary to first remove the trim panel.

SOURCE: replace 2000 buick park ave serpentine belt

Firt - study & write down (draw) the belt path,,
and be sure about it..

Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..

Repeat to put new one on..

Should be pretty easy..

honeymokey

• 3113 Answers
• Posted on Jul 20, 2009

SOURCE: 1991 buick park ave. security system set off,

Did you try the drivers door lock cylinder?