How to install and location of knock sensor
Link is for a 2003 PT Cruiser, but should be the same for your 2005. 2003 Chrysler PT Cruiser Changing Knock Sensor Engine Performance
2003 Chrysler PT Cruiser Changing Knock Sensor Engine...
Engine Performance problem 2003...
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: I have a 2003 PT cruiser w/ the check engine
It senses when the engine pings and the computer will adjust the timing accordingly. It is located in the block.
SOURCE: were i the crankshaft position
near the oil filter.. above it...under exhaust manifold one small bolt holds it on. If the is a no start condition look for frayed wiring near crank sensor..... it has a harness that hangs too low on some of those. & rubs on cv shaft
SOURCE: need to install knock sensor
It is located below intake manifold, in front of your oil dip stick. It will be screwed into the front of the block.
SOURCE: location speed sensor pt cruiser 03 touring car do
It sounds like the module is in limp mode. The speed sensor is most likely the cause, but it can be some other things as well. A scan will give a code stating the problem area.
The speed sensors are on the side of the trasmission that faces the front of the vehicle. There are 2 of them, and they are the same sensor. One is an input speed sensor located closest to the engine, the other is the output speed sensor.
1,848 views
Usually answered in minutes!
×