Horn beeps twice when I start the car - 2008 Mitsubishi Lancer GTS CVT Sedan

check horn operation then in owners manual will have options on how to add or remove alert when locking vehicle Handbook Guides Owners Jaguar Learn about your car

I would return it to the installer

My 2012 Hyundai Elantra Wont Start - CarGurus

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusJul 30, 2013 - My 2012 hyundai Elantra GLS would not start this morning. ... I hit my door unlock on mt Key fab and the doors unlocked fromt here I proceeded start my car.... it and it wont turn over just makes a light click. not like a battery issue. .... But if Istart from the zero position on the starter it doesn't start on the first try ...

No horn / No lights when I lock my car - Hyundai Genesis ...

www.gencoupe.com/.../244433-no-horn-no-lights-when-i-lock-my-car.h...

Mar 30, 2014 - 16 posts - ‎8 authors
I do not know what could have caused this but when i lock my car... ... lock yourdoors with your key fob(might have to hit the lock button twice) ... The alarm/horn should start beeping. ... 2010 Hyundai Genesis Coupe 2.0T R-spec in Karussel White.... My lights flash when I lock it, but the horn doesn't sound.

2013 Hyundai Elantra Engine Won't Turnover, Won't Start ...

www.carcomplaints.com/.../Elantra/.../engine_wont_turnover_wont_start...

The 2013 Hyundai Elantra has 19 complaints for engine won't turnover, won't ...

The programming works both ways . It will work also when you put air in.. Sometimes it takes an extra second or two to respond. Once the horn beeps twice the sequence is finished. You must repeat it again ..remember ...driverside front, passenger side front, passenger side rear...driverside rear. All within 3 to 4 minutes.

Check your owners manual. or call your ford dealership. Are any check engine lights on?

Hopefully you still have you manual. I will tell you how to reset the HHR, I found it in my manual. Turn the key to on, press lock and unlock at the same time on your key fob. The horn will beep twice telling you that you are in program mode. The left front turn signal light will come on, press the valve core letting air out of the left front tire. The horn will beep when left front is programmed. Then the right front turn signal will come on, let air out till horn beeps. Then right rear, same procedure then left rear same procedure. When that is done horn will beep twice again saying tire program is complete. Turn key off, make sure you air all tires back up.

The TPMS light (Tire Pressure Monitoring System) for that vehicle should function as follows.

If the light is on and steady, it means that the pressure in one or more of the tires is too low, and if the light is flashing, then it indicates that one or more of the tires are over-inflated.

1. Turn the ignition key to the "On" or "Run" position but do not start the vehicle. (If the vehicle has an electronic keyless ignition then place the ignition switch in the "ACCY" position)

2. Press the "Lock" and "Unlock" buttons at the same time on the vehicles remote key fob, and keep holding the two buttons down until you hear the horn beep, and usually this takes around five seconds. The horn beep will indicate that the learn cycle has begun.

3. Re-learn the TPMS system. Deflate or inflate air into the driver-side front tire for approximately 8 to 10 seconds and then listen for the horn to beep one time. (the horn might beep before the 8 to 10 second re-learn, or it could even take as long as 30 seconds after)

4. Repeat steps 2 and 3 for the remaining three tires. Also, the remaining three tires must be checked in the exact following order, the passenger-side front tire, the passenger-side rear tire and finally the driver-side rear tire. After the final TPMS sensor has re-learned then the horn will beep twice.

5. Listen for the horn to beep twice. When the horn does beep twice, it wikll be the indicator that the TPMS system has re-learned and reset.

6. Turn the ignition switch to the "Off" position, and then be certain that all four tires have the correct tire pressure as recommended on the drivers door, and the next time that the ignition is turned on, the tire pressure light should be reset.

Let me know if you require any further assistance.

Press the lock button once to lock then press and hold to beep the horn. Kind of have to press twice.

You have posted this in the wrong section (Oldsmobile) and no one will be able to find your posting to help.