Hi Antron,here's a link to your Cadillac codes,P1574 is stop light switch,that switch is attached to your brake pedal. http://www.engine-light-help.com/cadillac-check-engine-light.html Here's another link to what the stop light switch look's like.First look and see if your's is just loose and needs tightening,if bad,then remove electrical connector,then part and take to Autopart store and match up with new one and then install, http://www.autozone.com/electrical-and-lighting/stoplight-switch/duralast-stoplight-switch/cadillac/seville-sts/2000/8-cylinders-9-4-6l-sfi-dohc-ho/363562_0_0
SOURCE: How do I change my rear brakes on my 2000 Cadillac
you will need to remove the parking brake cable from the caliper then remove the lower slide pin bolt, flip the caliper up and pull out the old pads and install the new ones. You should get the rotors machined for the best braking performance or replace them.
SOURCE: my 2000 cadillac sts sunroof leaks on the
Chances are its the seals or rust. Check the top and see if it has any gaps... It may just be able to be repaired with a bead of caulk
SOURCE: where is the starter on a 2000 cadillac seville
under the intake manifold center above the engine block. read my tips section were I explain this location
SOURCE: How do I R&R front motor mounts on 2000 cadillac sts
Very easy, just remove front tires and unbolt, BUT I doubt you are asking right question. Not mounts, but mount in dead front center is problem. There are 4 mounts, transmission center back, left center and right center and front center. That takes full torque of motor and heat from exhaust. GM has a shield for exhaust.
SOURCE: How do you change the brake light on a 2000
Open the trunk and locate the screw that hold the lense assembly, remove screws, turn the socket that holds the brake bulb which will releas the socket, pull out the bulb, and replace with new bulb, reinstall in reverse order.
233 views
Usually answered in minutes!
×