SOURCE: how do I program for a new garage remote control
Here is a post that someone provided for a similar model:
http://www.fixya.com/cars/t2012164-universal_garage_door_opener
Hope it helps!
SOURCE: garage door opener
Sorry, the process is simple but too lengthy to post here.
Goto homelink.com
They make the system and have very complete instructions you can download.
PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.
SOURCE: How do i program the garage door transmitter that's found on the 2001 chrysler town and country
Go to this website and follow the instructions::
http://www.homelink.com
I programmed our 2 remotes in less than 5 minutes.
First I cleared the unit, then it went super-smooth....however, I had to use the 2 outside buttons. The middle button would not work??
I do not need 3 remotes, so no big deal here.
You can't. You can't . you can't ... Have the codes read and find the problem. Fix it. Could be just a bad key.
Turn your Chrysler vehicle off and press and hold the two outside buttons on your onboard opener system. Release the buttons once the red indicator light begins flashing. This will erase any previous codes programmed to your system.
Hold your garage door opener remote two inches away from the onboard system.
Press and hold the button you wish to program on your onboard system and the open button on your remote simultaneously. Release the buttons once the indicator light on the onboard system begins flashing.
Press the training button on your Chrysler's system until the light glows solid. If it does not glow solid, continue to the following steps.
Press the "learn" button on your garage door remote, located near the antenna wire on the back or side of the system, and return to your vehicle.
Press the training button on your on board system, hold it for two seconds and release. Repeat the press/hold/release step two more times and your remote will be programmed and ready for use.
451 views
Usually answered in minutes!
×