Where is the vehicle speed sensor located? The scanner read code PO717.

PO722 - output speed sensor
PO717 - input speed sensor.
P0581 – Cruise control system, multi -function switch input A circuit high

P0592 - I cant find any information on this code

Read the code, replace the part, No diagnostics done. Check the sensor, check wiring, and check the PCM/TCM. Most likely, you replaced a good part. Your mechanic should have told you if there was a PCM/TCM upgrade.

speed reading may be a bad vehicle speed sensor or broken / disconnected wire to that sensor ~ it should also light up your check engine light ~ confirm by using a scanner to get a trouble code

abs brakes, similar process ~ need a scanner to find out which sensor went bad or wire disconnected to it or visual inspection of those sensors

The PO717 code is for the transmission input speed sensor, or the wires. The sensor is located inside the transmission.

code po717 refers to turbine shaft speed (TSS) sensor-no signal===causes --wiring--TSS sensor--TCM/ECM .Replace the sensor first .

On your HONDA. the common problem is the Vehicle speed sensor .
I recomend get the car scanned with a diagnostic computer scanner.
Because the speed sensor malfuntion, will give a code and Afect the trans. with the performance.
The "D" light flashing is code refer to a transmission malfuntion.
But the code can be only for the speed sensor.
The AUTOZONE, ADVANCE and NAPA autoparts. they will scan your car without charge is just a Extra service that they give to the customers. If the scanner show the speed sensor code Just replace and the car will fine.

Code is for a speed sensor in the transaxle. You could have it replaced or tested.

CODE PO462 FUEL TANK LEVEL SENSOR VOLTAGE LOW. CODE PO717 TURBINE SHAFT SPEED SPEED SENSOR NO SIGNAL. CODE PO722 OUTPUT SHAFT SPEED SENSOR NO SIGNAL. CODE PO500 VECHICLE SPEED SENSOR CIRCUIT MALFUNCTION. SOUND LIKE YOU HAVE TCM ECM PROBLEMS GETTING TOO MANY CODES. COULD HAVE LOOSE GROUND WIRE TO THE TCM AND ECM.

CODE PO717 IS - A/T INPUT SHAFT SPEED SENSOR LOW INPUT CONDITIONS.YOUR INPUT SHAFT SPEED SENSOR COULD BE DEFECTIVE.CHANGE FLUID + FILTER IF IT HAVE NOT BEEN CHANGED IN A LONG PERIOD OF TIME.

dear friend:the code P0720 stands for out put shaft speed sensor.the following items need to be checked.wiring- vehicle speed sensor-ECM-PCM- TCM and the code P0705 stand for transmittion range sensor.plse check the TR sensor.