At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have a workshop manual for the vehicle but doesnt have a clear diagram. vehicle runs rough, idels ok blows white smoke but has a popping noise so i believe has an air leak but am not sure if the vacum/air hoses are in correct places as vehicle has had a motor transfer. Does anyone know where I could locate a diagramI have a workshop manual for the vehicle but doesnt have a clear diagram. vehicle runs rough, idels ok blows white smoke but has a popping noise so i believe has an air leak but am not sure if the vacum/air hoses are in correct places as vehicle has had a motor transfer.
Does anyone know where I could locate a diagram
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try the autozone.com website and register your car there. It's free and will give you access to an online repair manual for the car. The vacuum diagrams for your car can be found there. ( I checked) Hope this helped and best wishes.
sense its a deisel i would go with the vacume pump, diesels don't put out any or very little vacume, if you don't have vacume than booster won't work hense hard peddel. when you say you let up on peddel and hit it again you got better break tells me it is not getting enought vacume to booster. i would go for the vacume pump.
check power to turbo control valve on the vacum lines. if it has proper voltage than replace the valve. if it doesnt, than it is a problem either in the wiring or the ecm.
There is 1 or 2 vac solenoid on driverside rear of valve cover.
if there is only one then that one connects to the vac pump and wastegate actuator on turbo. if two vac solenoids,then other one goes to EGR valve on intake cover.
do not understand you what you mean. assuming your car was ok before you changed f/filter you need to bleed the fuel system of air. esiest to do would be to loosen fuel line at the injectors and have assistant crank the engine while you observe for clear fuel leak without any air bubbles from fuel line.tighten fuel lines and start engine. might have to repeat a few times. good luck.
I have a workshop manual for the vehicle but doesnt have a clear diagram. vehicle runs rough, idels ok blows white smoke but has a popping noise so i believe has an air leak but am not sure if the vacum/air hoses are in correct places as vehicle has had a motor transfer.
Does anyone know where I could locate a diagram
×