What is the torque specs for the connecting rod for the 2002 kia pregio?

Question edited for clarity.

valve clearence for kia pregio 2.7diesel J2 engine bigend ...

JustAnswer https://www.justanswer.com > Australian Car Repair
Feb 21, 2011 - Hi, it's Glenn here. I can help you with your question. Valve clearance: Cold:- Inlet - 0.30 Exhaust - 0.38. Conrod Torque: 69Nm, back off, ...

What is the Valve clearance for the 2002 kia pregio diesel ...

Answers.com https://www.answers.com > Auto > Asian Cars
Oct 24, 2022 - 2mm for intake and .3mm exhaust. or .008in and .012in when the motor is warm. not sure for cold motor. What is valve ...

not sure if this link will help you out.
2014 kia rio rod and main cap torque spec Google Search

What are the cylinder head torque settings for a KIA K2700

www.answers.com > ... > Categories > Cars & Vehicles > Asian Cars > Kia
What is the torque specification for the cylinder head on a 2002 Kia Sportage? ... the correct torque for cylinder head bolt of kia pregio 2.7 diesel is 130-135ft-lbs. ... Thehead bolt torque settings, on your Kia 2.7 diesel engine, is 70 pounds per ...

1996 Kia Pregio specifications, information, data, photos 7623

www.carfolio.com

i have converted my kia pregio alternator to recondition alternator for kia carnival problem is when i used all electrical such as aircon and light the alternator was not charging properly during traffic therefore when I need to turn off the engine i need to charge the alternator by pressing the gas for few minutes before turning off. please advice. thank you

main bearings torque is 18 ft lbs. plus 90 - 94 degrees, rod bearings torque is 13 - 16 ft lbs. plus 90 - 94 degrees.crankshaft damper bolt torque 80 - 94 ft lbs, fly wheel bolts torques 94 - 101 ft lbs.

Tighten toque main bearing cap for kia prigio

22 - 24 ft. lbs. for the rod caps and....
Cylinder Head Tightening Torque and Sequence.

Tighten cylinder head bolts in order shown.
Tightening torque: 36.1 ft. lbs. (49 Nm, 5 kg-m)

Loosen bolts in reverse of order shown.

Retighten cylinder head bolts in order shown.
Tightening torque: 18 ft. lbs. (25 Nm, 2.5 kg-m)

Mark cylinder head bolts for rotational reference.
Rotate cylinder head bolts 90°(1/4 Turn) in order shown.

CAUTION:

• Do not reuse the old cylinder head bolts.

TORQUE SPECIFICATIONS kia rio
Cylinder Head Bolts:
(21.7ft.lb) or (3.0kgf.m) 90?

check your service manual for torque specs or look up the torque specs online for the number or letter it has on top of the bolt