Diagram front hub replacement for 1996 olds aurora

SOURCE: replacing front wheel hub assembly 1996 Dodge caravan

first jack up the van remove the wheel remove the brake caliper and rotor remove the axel nut then remove the three bolts on the back of the hub tap on the hub with a hammer it should come out hope this is helpful

SOURCE: A simple component location diagram needed.

stop by any local GM dealership to see if they still have the manuals for your car and you can try this place Schram auto parts 1-800-292-1032 or online at www.schramauto.com

Greg Bernett

• 2993 Answers
• Posted on May 13, 2009

SOURCE: Need help replacing front hub

Here's the steps....getting some pics for you....hang on a minute or two.

Front Hub Removal & Installation To Remove:

1. Remove steering knuckle.
2. Using a suitable slap hammer, remove wheel hub assembly.
3. Using a suitable bearing press, remove outer bearing, oil seal, outer bearing race and preload spacer.
4. Remove inner oil seal, inner wheel bearing and inner bearing race.

1. Using a suitable bearing press, install bearing races in steering knuckle.
2. Pack the bearings and hub area with lithium grease.
3. Install inner bearing in steering knuckle.
4. Lubricate lip of NEW inner seal and press seal into knuckle.
5. Install preload spacer into bore.
6. Install outer bearing into bore.
7. Lubricate lip of NEW outer seal and press seal into knuckle.
8. Using an appropriate tool, support inner wheel bearing and press wheel hub into knuckle with a force of 2500kg.
9. Install NEW inner seal.
10. Install knuckle assembly.

SOURCE: diagram of front hub assembly for 1994 mercury sable.

Best solution to your problem is going ot the junk yard asking them for a left front knuckle. They will charge you about the same price for all this stuff as the auto parts store will charge you for a wheel bearing. After you have this knuckle you will be able to take a few things off of it and be able to put it on with only remvoing like 3-5 bolts.

SOURCE: Need diagram for replacing front hub assembly on

to get the cv joint axle off on the 98 corolla, you have to remove the wheel, shock/strut, and control arm, pop it out of the transmission, and replace, i think there is a cover that you might have to take off first before you get to the cv, its been about 6 months since i replaced mine, sorry... but good luck and god bless, Please Rate me!