Where is the starter located in a 1992 BMW 325i?.....Should i do it myself or just bring it in?

Most likely the contacts on the ignition switch are worn out .you will find this at the end of the ignition barrel .

i have a 2002 BMW 325I
I tryed to change the remote control battery.. now the car does not start... HOw can I turn off the anti theft system... or what can I do to start the car

it is on the drivers side of the engine right where the engine and transmission meet.

the starter will be at the flyweel, typically at the 8 or 4 o'clock position.

Follow the large, positive battery cable to the starter.

BMW ignition lock replacing.

According to manual no special tools needed. here procedure!

1. Ignition elec switch. Disconnect battery. 2. remove trimpanel from lower leftside of instrument panel. remove screw retaining lower steering column and remove cove. 3. remove slotted screws on both side of switch. 4. relase tabs and remove switch from elec harnass and remove sealer.. note: before mating new ignition elec switch check that switch is in correct position. seal screws again.
2. Ignition lock cylinder replacing. 1. insert master key and turn 60 deg to radio position. 2. inset piece of stiff wire into opening in lock cylinder and pull cylinder out. (Note early models up to 10/95 turn lock cylinder back 12 deg to release)

The fuse box is located under the hood in the driver side corner closest to the windshield. It is about half a foot long by 4inches wide and is black. take the lid off, and each fuse is numbered... there is a legend on the reverse side of the lid that will tell u what each fuse corresponds to.

Perhaps this link will be of some help.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004a3c7

hi there see if this picture helps you locate it .

1994 BMW 5 Series Blower Motor Resistor Location BMW Repair:

AC blower motor resistor 325I 1992 E36, blower motor resistor, dial control



riz.

There is no fuse but it has a circuit breaker. I changed the comfort relay and everything is working. spent $28.00.

The only way to obtain a code is to call BMW with the serial number which is located on a stick at the back of the radio