Hi Eddie,Here's a link to a Nissan part site,the starter relay is 25224G.If you look at the truck picture,it has letter's,find letter G AND THAT'S WHERE THE STARTER RELAY IS,BY THE WAY,i HAVE A MINT 85 nISSAN 720 4X4,HERE'S A VIDEO OF IT,TAKE CARE. Parts found for 1996 Nissan Hardbody Pickup 1995 1997 Body Electrical Relay CHECK MINE OUT. 85 Nissan 720 4x4 2 4 Weber conversion
SOURCE: troubleshooting air conditioner thermostat 1995 nissan pickup hardbody
The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.
Good luck!
SOURCE: where is the body control module located on a 1997 town & country
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
SOURCE: Location Of Starter relay switch
sometimes its the simple things. On the foot pedal for the clutch are rubber grommets that push the switch in on the manual trans. they get old and fall off or develop holes in them so the switch does not get depressed.
SOURCE: need to know location of throttle position sensor
Not 100% sure on your exact car but nissan TPS usually are on the opposite side of the TB from the butterfly return spring.
Testimonial: "thanks a million no information on installing & adjusting in repair manuel"
SOURCE: where is the thermostat located on 1997 nissan
Look at the upper radiator hose follow it down to were it clamps to the engine This part is called the goose neck Thermostat is located under it and what you need to do is first drain some antifreeze out of the radiator a QT or so remove the hose clamp remove the hose remove the two bolts that hold down the goose neck the t stat is under it lift it out clean off the old gasket real good its important to getting a good seal with the new gasket and not cracking the neck when your reinstalling put new t stat in put new gasket on you may want to put some sealer on it then reinstall everything else in reverise order don;t over tighten goose neck bolts about 18 ft lbs
4,222 views
Usually answered in minutes!
×