1990 nissan bluebird sss fuel pump not getting power

To remove the starter motor on a 1994 Nissan Bluebird SSS 2 litre ATTESA-U13 engine (AWD), follow these steps:

1. Disconnect the negative terminal of the battery to prevent any electrical accidents.
2. Locate the starter motor, which is typically located near the transmission bell housing on the engine block.
3. Remove any heat shields or other components that may obstruct access to the starter motor.
4. Disconnect the electrical connections to the starter motor, including the wiring harness and solenoid.
5. Remove the mounting bolts that secure the starter motor to the engine block.
6. Carefully slide the starter motor out of its mounting position and set it aside.
7. Install the new starter motor by reversing the removal steps.

As for finding a repair manual for your Nissan Bluebird SSS, you can try searching online for a digital version that you can download, or you can purchase a physical copy from a reputable auto parts store or online retailer. Additionally, you may also be able to find helpful information and step-by-step guides on online forums and websites dedicated to Nissan vehicles.

Go to a parts department at a Nissan dealer. They may have to order it if you're stateside since Bluebird was never imported to the US.

You really need a manual to do this job. I can tear any thing down. But I have to have torque specs and sequence, plus timing alignment. Both are critical. Just a note.. Since it is a 94. If you have really high mileage, doing a head job, may blow out the piston rings. Just wasted money.

The bleed screw should be located near the water pump. Trace your radiator hose and you should find in near the manifold. Some bleed screws are painted blue on top so you can find easily

bluebird, that is JDM car, what country?
a 1990 /94 Nissan toyota bluebird?????
post country, wiring varies by that. and year, make , model and sub models and special radio options offered, in each country.
if a usa car. alldata.com has the answer under wiring ,radio.
read it.

you should have a fuse some where to

Yes, it is an 'in tank' pump and filter system

It's located in the fuse box under your hood. Should be near the fender wall or the firewall

its located in the fuel tank makes up part of the fuel level sending unit

more than likley find the trani needs replacing