I need a diagram of the engine where it shows the location of the iat sensor for a mits eclipse 2004 rs.

For its exact location on your vehicle,click the link below:----
Chevy Monte Carlo IAT Location http://technoanswers.blogspot.com/2012/11/chevy-monte-carlo-iat-location.html

--------
These will help.
Thanks.

Vehicles: all computer-controlled internal compustions engines equipped with an IAT (Intake Air Temperature) sensor

Intake Air Temperature (IAT) Sensor

Operation - IAT

This sensor is a resistor based sensor which detects the intake air temperature. According to the intake air temperature reading the ECM/PCM will control the necessary amount of fuel injection.

ECM = Engine Control Module (aka "the car's computer")
PCM = Powertrain Control Module (aka "the car's computer")

idle air temp sensor

Color wires? The IAT sensor is part of the mass air flow sensor. The wires in the MAF harness that go to the IAT sensor are: Brown is ground, Red/Purple is the 5v reference, and Green/Yellow comes from the IAT into the Atmospheric Pressure Sensor and out to the computer.

Hope this helps. Good luck!

It's an RS, assy plant Bloomington-Normal,IL

Fig. Component Location Chart-2000 MPV

1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) (front, RH) 11 Heated oxygen sensor (HO2S) (rear, LH) 12 Heated oxygen sensor (HO2S) (rear, RH) 13 EGR boost sensor 14 Power steering pressure (PSP) switch 15 Main relay


Fig. Component Location Chart-2001 MPV

1 PCM 2 Mass air flow (MAF)/Intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Engine coolant temperature (ECT) sensor 5 Crankshaft position (CKP) sensor 6 Camshaft position (CMP) sensor 7 Knock sensor 8 Heated oxygen sensor (HO2S) (front, LH) 9 Heated oxygen sensor (HO2S) (front, RH) 10 Heated oxygen sensor (HO2S) (rear, LH)* 11 Heated oxygen sensor (HO2S) (rear, RH)* 12 EGR boost sensor


Fig. Component Location Chart- 2002-06 MPV

For Hyundai Car 1999-05 - Intake Air Temperature (IAT) Sensor Location (check several options):

1.- The IAT sensor is located against the firewall to the left side of the engine. It is combined with the Manifold Absolute Pressure (MAP) sensor.

2.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

3.- The IAT sensor is located in the air plenum assembly. On some vehicles it is combined with the MAF sensor.

4.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

5.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.

6.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.


In the next graphic, check the position 2...



FIG : Underhood sensor locations-Elantra 2004-2005 2.0L engine


Hope this help (remember comment and rated this) TY for using Fixya.

Its located on the intake manifold near the goooseneck

If your looking for the Intake Air Temp/Manifold Absolute Pressure sensor (IAT/MAP)(2003 model year and up) It is on the top of the intake manifold, just to the left of the #3 injector fuel line. There are 2 small Torx screws holding it.

Try “autozone.com” or your local library for diagrams and step by step instructions.