SOURCE: how to put an alternator in a 1998 mitubishi eclipse
Well generally and very basically, ya, unplug the wires from Alternator then remove the bolts that attach it, remove the drive belt, Then, reinstall the new Alternator, then put belt on.. retighten the bolts.. reattach the Wires.. ya should be good to go. Check Check Check.
NB: Take note of how "Tight" the belt drive is and try to replicate that tension when finished.
SOURCE: crankshaft position sensor location
if u pull the battery and battery tray u can easily reach this
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
SOURCE: need firing order for 2003
Firing order - 123456 I hope you understand my little diagram. Not to good at copying & pasteing diagrams. I hope this helped and good luck.
5 6
3 4
1 2
______________
5 2 4 1 6 3
Front of vehicle
SOURCE: 1992 eclipse engine cranks but
SOUND LIKE TIMING OFF.WORN TIMING BELT SLIP TIME.IF YOU ARE GETTING SPARK AND FUEL VALVE TIMING OFF DUE TO WORN TIMING BELT.
185 views
Usually answered in minutes!
×