Since it worked and now it doesn't. A band has broke in the transmission.
When was the last filter /fluid change done on transmission also check under drivers side of transmission at gear select connection and cable may be disconnected or damaged
Your 1997 Venture locks the gears when not all doors are closed.
I find that when I get out and slamm the sliding doors once or twice, the problem goes away. ( A little WD40 on the door sensors seems to help).
This is automatic, right? Have your gear checked and maintained... well, did you change/check your transmission fluid at all?
SOURCE: where will I find maintenance schedule for 2007 ford edge
You could certainly give this a shot:
https://www.fleet.ford.com/maintenance/maintenance_schedules/GetYMM.asp
Drive safe =]
Sean
SOURCE: 2005 Chevrolet Silverado 2500HD 4x4 Oil Change Reset
Not positive 05 is the same but on my 02 you turn the key to the on position and pump the gas pedal 4 times.
SOURCE: Toyota 4Runner/maintenance schedule at 140K miles
The maintenance schedule is an outline and should be followed if you want to keep your vehicle in good condition. the maintenance items listed in the schedule are performed at their set intervals for a reason. Manufacturers have found the wear limits on certain parts and those parts may need to be serviced or replaced at those intervals or catastrophic failures may result.
SOURCE: know how to change the oil pump in my 1997 chevrolet SILVERADO?
The oil pump is in the the oil pan so you will need a new oil pan gasket and some form a gasket as well to put the pan back on, because you will have to take it off, you will see the oil pump a soon as you take the pan off, it will have a tube connecting to the pick up screen and to the block, remove bolts from the block and remove oil pump. be prepared the primming rod will probably come out too. itll need to go back of course, make sure seated in correctly because the primming rod runs off the cam. make sure the surface area for the oil pump gasket is clean before reinstalling new oil pump same goes for oil pan. after everything back together refill oil. It is best to test the oil pump before starting for your engine. the best way to do this is to remove the distrubuter if it has one if it has electronic ignition it will have a cap where the distributer went remove that and you will see the top end of the primming rod, fit appropriate socket on the primming rod and use a battery gun to spin, look inside oil fill cap and make sure you see oil flow or oil pressure on your gage if equiped, CAREFULL!!!!!! make sure the socket on battery gun has no way of falling off, or you will have to remove oil pan again to retrieve it.
Another way to prime pump is to disable igniton main power like remove the coil wire, or main power wire for electronic igniton so you can turn the motor over with out it starting, once again turn it over until you know you have oil pressure with the gage or through oil fill cap. put ignition back together start the car and once again confirm oil pressure. If every thing looks good your done Good luck
SOURCE: Check VSC is on with
Hello and welcome to FixYa...
the
Engine light and VSC light will come on together when a fault code is stored in
the computer
...the codes will need to be read to determine what caused it, based on that information, repairs needed can be taken to correct it...i hope this helps and good luck with the Lexus
166 views
Usually answered in minutes!
×