Question about 2003 Dodge Grand Caravan

1 Answer

I'm replacing a fuel injector for 03 dodge grand caravan. According to the code, it is saying injector number five. I'm confused about the numbering system for the injectors. Which one is number five?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Dodge Expert
  • 304 Answers

Front bank is 2,4,6 rear bank is 1,3,5 Cylinder numbers run front to rear.

Posted on May 21, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

lbecker478

  • 86 Answers

SOURCE: 1998 DODGE INTREPID 2.7 MISSES

fixed the problem....unhooked wires from pcm to harness at the connector next to fuse box under hood,sprayed with electrical cleaner and then dried with air compressor...rehooked and car is running great....code engine service is also off....

Posted on Apr 18, 2009

chryslerguy

  • 323 Answers

SOURCE: CODES NUMBER 1 INJECTOR CIRCUIT OPEN.1998 DODGE INTREPID 2.7

The ground wire from the injector to the pcm is open. The injectors share the same power wire but the pcm grounds each one individually to fire.

Posted on Apr 20, 2009

SOURCE: 1992 Dodge Grand Caravan 3.3l dies on highway.

Its normal for the pump to run for three seconds then shut off if the car engine is off. . This indicates that the fuel pump turned on and the pressure did reach specifications. If the pump did not reach pressure the pump would continue to run, You need to check for proper pressure with a gauge. If tthe pressure is ok then you have another issue like an ignition module or crank sensor if applicable. You may have to drive the car with the fuel gauge hooked up to see if you still have pressure when it dies.. I know you said you replaced the pump already but do you have the same issues as before you replaced it. This would indicate which direction you need to go now. If the same then its prabably not the pump.

Posted on Sep 20, 2009

Dsl Apprenti

  • 37 Answers

SOURCE: number one injector bank on 2006 dodge cummins

you'll notice on your valve cover gasket there is two connectors.. the one up front is your 1-3 the one in the rear is your 4-6... you can remove your valve cover and check the connections from the injector connectors to the
connectors on the valve cover.. check for an open.. however you could also have a fault internally in 1 of your injectors in that bank as well.. hope this info helped..

Posted on Feb 03, 2010

Zaraki

  • 834 Answers

SOURCE: WHERE IS NUMBER 6 FUEL INJECTOR LOCATED

The #6 fuel injector is located with the #6 cylinder and I have added a firing order and cylinder layout diagram that should help you out.


1730e85.gif

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 dodge grand caravan won't fire. Do I have a fuel pump reset, and where


There is no fuel reset button. If it cranks good but won't start, have a helper crank it while you visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure, Also, check fuel injector pulse. Are there any applicable trouble codes?

Mar 19, 2017 | 2000 Dodge Grand Caravan

1 Answer

Misfire on #5 cyl


2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers
Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305
A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan
Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An


Dec 05, 2015 | 2005 Dodge Grand Caravan

1 Answer

What is code p017.2 for a 2002 dodge caravan


This is the closest I've come to the code you are looking for. I searched all Dodge codes and didn't see any with a "point 2" but I found code P0172. According to EngineCodes.com your fuel mixture is probably too rich. This is what the site had to say:

Possible Causes for this Code:
- Faulty front heated oxygen sensor
- Ignition misfiring
- Faulty fuel injectors
- Exhaust gas leaks
- Incorrect fuel pressure
- Faulty Mass Air Flow (MAF) sensor
Read more: http://engine-codes.com/p0172_dodge.html#ixzz35waCcFhN

This code is detected when:
- Fuel injection system does not operate properly.
- The amount of mixture ratio compensation is too large. (The mixture ratio is too rich.)

Read more: http://engine-codes.com/p0172_dodge.html#ixzz35waXE700

Possible symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Excessive Fuel Consumption
Read more: http://engine-codes.com/p0172_dodge.html#ixzz35waruoIU


P0172 Dodge Code Description:

With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the heated oxygen sensors 1. The Engine Control Module (ECM) calculates the necessary compensation to correct the offset between the actual and the theoretical ratios.
In case the amount of the compensation value is extremely large (The actual mixture ratio is too lean.), the ECM judges the condition as the fuel injection system malfunction and light up the MIL (2 trip detection logic).
Read more: http://engine-codes.com/p0172_dodge.html#ixzz35wbfFdyj


Hope this helps!

Jun 27, 2014 | 1999 Dodge Grand Caravan

1 Answer

I have dodge grand caravan sport the check engine is on the code is P0172 say sistem too reach bank 1


code p0172 refers to system too rich bank 1===causes --intake blocked (air filter) EVAP canister purge valve---fuel pressure---EGR system--injectors--HO2S (oxygen sensor). The first thing to check would be the oxygen sensor and air filter. Then check the fuel pressure in the fuel manifold to check for fuel pump/filter/ pressure relief valve that may be causing an injector fault

Sep 28, 2013 | Cars & Trucks

1 Answer

Engine code pos302


Code 302 is for a miss on cylinder number 2. It could be ignition or fuel related.
The spark plug and injector would need to be checked.

Jan 10, 2013 | 2001 Dodge Grand Caravan

4 Answers

Is E85 safe to use in the 2002 Dodge Grand Caravan Sport?


If your vehicle is equipped with a Flex-Fuel engine it is safe to use E85. If your vehicle is not equipped with a Flex Fuel engine, E85 will cause all kinds of driveability problems including a no-start. The vehicle should say "Flex-Fuel" on it or there will be a green "Leaf" emblem somewhere on the body.
For a 2002 Dodge Caravan, the best way to positively identify the engine is to look at the VIN. The only engine code that is Flex-Fuel is engine code "G". The engine code is the 8th digit of the VIN. The 10th digit is the year of manufacture and should be a "2" on your vehicle. If there is ANY OTHER engine code, DO NOT put E85 in the tank.

Mar 27, 2011 | 2002 Dodge Grand Caravan

1 Answer

2001 dodge grand caravan , check engine light p0202 ,i have checked #2 fuel injector and tested all injectors. all injectors tested between 12.6 and 12.8 ohms for all. i have replaced the pcm and it burned...


If the noid light is working, the pcm is good. Why do you say it burned out? I would check ac voltage at each injector with engine running. If #2 has lower voltage than the others, you probably have a bad wire or connector.

Nov 07, 2017 | 2001 Dodge Grand Caravan

1 Answer

Transmission


they should be replaced.

Aug 29, 2008 | 1999 Dodge Grand Caravan

Not finding what you are looking for?
2003 Dodge Grand Caravan Logo

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...