So your saying the fluid lines and fittings are not clogged, correct? Next, I have to check voltage and ground for washer pump. If your missing either one, have to track that circuit. Go from there.
The lite green wire at washer motor is voltage and the black wire is ground. If no voltage that will lead back to wiper/washer switch on steering column or the wiring circuit. If your going to work on steering column, make sure you disarm the air bag.
SOURCE: Front windshield washer won't squirt
Sometimes it's as simple as clogged jets where the solution comes out. I would take a fine needle or pin and insert it into the hole where the solution comes out to see if it frees it up enough to squirt first. They sometimes get clogged with salt or dirt.
jackiaria
SOURCE: Removing the windshield washer reservoir in a 2002 Chrysler T&C
REMOVAL
INSTALLATION
SOURCE: windshield wiper fluid will not squirt - wipers are fine but no fluid comes through
Either the pump is bad, or the nozzles are clogged.
SOURCE: 2000 Chrysler Sebring windsheild washer pump
check the fuse panel for weak or blown fuse in the wiper/washer circuit if that all checks ok then using a test light or volt meter then find the washer pump leads at the bottom of the washer pump itself and with the circuit activated make sure you have 12 volts going to it also check the ground wire to it to insure proper ground if voltage is present then remove the motor assembly from the washer housing and relace the motor
Testimonial: "Quick, informatve response...perfect & thanks!"
289 views
Usually answered in minutes!
Lines are clear and were they squirt out the washer motor good won't push fluid to windshield and wipers work fine any help please?
×