SOURCE: 2001 Mustang GT rear brake job
yep this is a two man job, onece you get air in the lines is better to do all four, my has abs and i was able to do it, but next time don't take anylines lose just turn the piston clockwise and you should be able to push it in.
SOURCE: POWER BRAKE BOOSTER REMOVAL,HELP!
remove master cly. from booster. then under dash remove clip & pin from brake pedal . pull carpet down remove 4 nuts . pull off booster..
SOURCE: 2001 sonoma parking brake petal wont lock into place
There's a ratchet in the top of the pedal which holds the pedal down when depressed. This ratchet is worn, broken, loose, or it just needs lubricating. I would first try WD-40 on the top of the pedal where it attaches to the frame/chassis.
SOURCE: brake light and abs light stays on after i
sounds like the brake fluid level sensor maybe stuck . it is in the master cylinder reservoir. if you open the cap you will see a float in there. push on it and tap the side of reservoir and it will float back up. let me know if you have any more question. good luck
SOURCE: how do i know if brake booster is gone ? 2001 gmc
Do you by any chance hear a hissing noise from under the dash? If so, yes, you have a bad booster. For it to do what you're saying, it would almost have to have a vacuum leak. However, if there is a problem with something in the ABS system, you should have an ABS warning light on. Also, ABS can make the pedal fade, but I've never heard of it making the pedal hard. Your diagnosis of a brake booster does sound likely, but I'll admit I can't be sure -- this is an odd one.
Testimonial: "thanks, heard a hissing that i thought was coming from under the truck -- have to check tomorrow - actually my father's truck. have to get back there"
77 views
Usually answered in minutes!
×