Car cranks but dont start

How is the crank sensor?

When you squirt water on plug wires and the car stalls, that means that your plug wires are bad. PLUG WIRES (not rotor, cap, or any sensor).
Replace your spark plug wires with new, and you should be fine.

Hi, there are a few possible faults that i can think of: the first could be that the battery may be low and does not crank the motor. The second could be that the starter needs attention.(you do not say whether any ignition lights come on) When the key is turned and the motor does not crank, the ignition,battery or the starter could be faulty. I would suggest you start with the battery then test the starter, if the battery is good and the starter is okay then check the ignition. All the best.

Timing, Vacuum leak. The MAF may need to be cleaned. There are specialty spray cans for this.

not for sure but it could be your cam sensor. if the check engine light is on then take it to a parts store and they can run a scan and give you more information

WHEN THIS CAR HAS AN AIR LEAK AT THE INPUT IT SHUTS OFF!!CHECK FOR LEAKS AT THE INPUT MANIFOLD AND REPLACE BROKEN PARTS IT WILL BE OK!!THEN TAKE IT TO THE GARAGE AND RESET THE MIL LIGHT.TEST DRIVE AND CHECK FOR FURTHER DTCS!!!

Could be head gasket,try head gasket fix.Could work.

• Well, that belt drives everything including the water pump. When the belt broke and you drove it no coolant circulated and the exhaust glowed from overheating. A red glowing manifold usually only happens from excessive heat caused from modified engines. But in this case this is almost surely what happened. You are lucky you did not blow your engine. Park it and let it cool down for a few hours.

Regards, Tony

try adding some HEET to it it is a gas line antifreeze product which also takes care of water in the gas other then that you may need a fuel pump which will require a towe

this engine fuel pump prassurae low. it fuel pump celan. Your problem sovel